Network Management

Hi,I´m trying to generate interface availability and interface utilization report for unified APs on Prime Infrastructure 2.0, but it doesn´t display any information. I have created device health and interface health templates under desing/Monitor co...

Hi,My NCS appliance will not start as the disk is full (95%). I can login as admin but unable to log in as root to check the directories nor change the root password.I have also run ncs cleanup, but it did not resolve the issue.Any assistance is appr...

HI, I have been asked to do some research on a network design that eliminate the need for IDF's or at least the most of them. So we are going to add a new location which will have 3000 drops and instead of running all those drops back to a IDF or MDF...

HI, does anyone know if there's a MIB supported by NXOS (5548 specifically) that returns real-time input voltage level for each PSU? Many thanks,Tim

Hi,is there a way to show the detailed reachability history of a specified switch?Although there's a report called "wired device availabilty" where you can retrieve the average availability of the specified device, I would like to see detailed inform...

Hi,I'll have to install 2 Prime Infrastructure physical appliance in HA.My customer is wondering if each appliance can be attached to 2 Nexus with an EtherChannel Link.I can't find any answer to that in documentations (Config Guide, AdminBook, ...).I...

hi,whether the cisco prime 2.1 will support cat-os devices??the model device is ws-6506-e  RgdsTD

 I have a catalyst 4500 (cat4500 - ipbase - M), versión 12.2 (44)SG1. Cisco WS-C4510R-E (MPC8245). Attached configuration files.And I want to upgrade to the lastest versión OS.Where I can download it? 

Hello all,Show hardware capacity powerXXX-NX01 (2*6000.00W 220v AC)Power Resources Summary:------------------------Power Supply redundancy mode(administratively):                         PS-RedundantPower Supply redundancy mode(operationally):       ...

Hello,we are running DHCP snooping and ARP inspection on 2960 running 12.2(50)SE5. If there is a dhcp snooping denial it is logged with:SW_DAI-4-DHCP_SNOOPING_DENYThese messages are logged every few seconds as long as the event is active.I was wonder...

Hello, We are a new user with Prime and have a couple questions. It seems to be quite a power yet complex tool so figure we have a ways to go. I have the system up and running and am able to do a discovery and pull the configs so it seems basic opera...