Network Management

Hi there.I'm trying to get the VLAN's a trunc port is a member of using snmp using the CISCO-VTP-MIBThe following key holds this information: .1.3.6.1.4.1.9.9.46.1.6.1.1.4(.iso.org.dod.internet.private.enterprises.cisco.ciscoMgmt.ciscoVtpMIB.vtpMIBOb...

Dears,It appears in LMS 4.2, Inventory Collection, is trying to query some POE MIB or MIB entries that older devices don't support.This makes devices fail saying: 'device sensed but collection failed' My biggest issue is that RME categorically bins a...

LMS 4.2.1 W2K8 R2I seem to be unable to generate a syslog report that contains > 10,000 records.  And I don't mean with run type immediate either.  I am scheduling them to run at the next 5 minute interval (incidentally, why not have an option that j...

LMS 4.2.1 on W2K8 R2I just want to send an email for any sev 1 or 2 syslog messages received.  I set up an automated action that looks like this:Automated Action Summary Name: Critical Events EmailDevices: *State: EnabledParameters: TO=John.Doe@examp...

We have CPU reports set to run daily for some of our higher priority switches, and we've noticed that some of the data isn't meshing with what we see on the switch. We have one heavily utilized switch that reports near 100% CPU utilization sometimes....

Hello,Did anyone notice that Save button is not woking on Syslog Purge Settings page  (Admin > Network > Purge Settings > Syslog Purge Settings) when Email: field is not empty. An Reset button is not working at all.This is the Cisco Prime LMS 4.2.1.I...

Dear,Apparently, dom is enabled on our switches, there is also an entSensorThresholdNotifiction trapdefined in this mib. Wich snmp command do we use to activate the trap if a threshold is triggered ?Is it "snmp-server enable traps entity" ? or some o...

Hi All,I am facing this issue with my LMS setup. the rmedbengine is not getting started. The CW was down due to low memory space . After restart the RMEDBEngine is not coming up(Made some free space avaiable in the drive) . I have done transaction lo...

HI,Cisco 7600 running "c7600s72033-advipservicesk9-mz.122-33.SRE6.bin"what i'm trying to do is get the bgp peer state  using the OID   .1.3.6.1.2.1.15.3.1.2 , however , i only get the ipv4 adresses , is there a way i can get the ipv6 peer states via ...

Hello,I have a Nexus 5596UP with a layer 3 module installed.Does anyone know if this will ever support netflow?I know the 5596UP doesn't have the correct hardware for it, but does the layer 3 module not have the ability to do this for it's own ports?

Crew,I've been experimenting with implementing TCP syslog with multiple devices in my network, and I've come across a few instances where it stops and doesn't recover.  For instance, there was an extended maintenance where we reloaded one of our rout...

hello everyone,it is long time and i think that CIDR is just a routing method that allows routers reduce routing table size.tonight, i was reading a book mentioning that CIDR saves address space.This makes sense of what follows:assume your organizati...