Other Collaboration Subjects

6608 connects to Nortel 81C PBX. Customer has seen slip increasing on PBX side, how ever I didn't see any slip on 6608 using dick tracy utility. Now PBX is configured as netwrok side and external clocking, mine is user side and internal clocking. Any...

Hello cisco guru,Any thoughts or advise regarding the warning message below. What should be done. This happen after we update the CISCO IOS and DSP card of our as5300.Router#conf tEnter configuration commands, one per line. End with CNTL/Z.Router(co...

Hello,We have a requirement to register a 7960 on the Internet to our CCM which is on private address space behind a firewall with NAT. How can this be done? I have thought of DNS but it would require an organizational CCM change (DNS instead of IP...

Hi,got one 2611 running 12.2.7c with 1xNM-2v and 2xVIC-2FXS. Talking to a 2620 running 12.2.14c with 1xNM-2v and 2xVIC-2FXO-M3 via VoIP. Most of the time things are working fine however on occasion one of the FXO ports locks up. I just noticed that t...

Is there anyway of automatically forwarding a call to an external number when an IP phone de-registers.

Dear All, My office have two CCM: one publisher and one subscriber.After reinstall the OS and CCM for publisher, I have restore the data to Publisher using BARS.However, should I need to reinstall the subsciber too? Thanks.C.K.

Is there any way of using an external database for Authentication? Something like ACS 3.3 or Active Directory.

We need to change the ip addresses in our CCM4.1 (both pub and sub). We want to confirm if CCM4.1 need to be reinstalled and all the ip phones database need to be reinstalled again, for example BAT.Thanks.

Anyone know how to do this on 4.1.2

In some cases there can be more than one summarized address for a single interface, to represent a single internetwork to be advertized using eigrp. Can there be more than one summarized route placed on a single interface, or would I have to get all ...

Hi,I know that in CM4 the Authintication is set to Windows only. It looks like a better practice.But when you install Extended Services (for TAPS) on the Publisher it sets it back to Mixed mode...Can it be set back to Windows only?And the CDR definit...

Suppose I have 5 locations wan network and i installating CCME router ( cisco 3845 router ) at central location with 5 phones at each remote site can some send me configuration guide for same Does cisco SRND guide for CCME regards lalit Sujera

Im using SRST and when CCM is not available, phones enter in fallback mode correctly.The problem here is that some ghost speed dials appeared in some phones (1).How can I recreate the config files for SRST ?Something like Enabling Caching in TFTP for...