Other Collaboration Subjects

Hello,The majority of my European locations are currently using some type of DECT phones. I realize that the 7920's are supposed to be the solution for this but there are a few problems with them and in addition there is already a great investment in...

We have recently upgraded our CCM from 4.0.2a to 4.0.2a sr2 and also upgraded our 7912 phone loads to 6.1.0. Since making these changes when we dial a number on the phone and then lift the handset the call is lost, this happens intermittently. Can ...

This link shows all Cisco supported Antivirus for CCM. But it shows CA's eTrust Antivirus 7.0 is only supported on CCM3.33. Our customer has CCM 4.12 and their corprate Antivirus is CA. Has anybody know CA can be running on CCM4.12?http://www.cisco.c...

Can I do LLQ on the interface and LLQ on the queue for the CB shaping on the same interface?

After upgrading the ICS 7750 SPE 310 from 3.1.4b to 3.3.4, i am trying to access the phone directory from the phone and it is asking me for an authentication required, username and password pop up. I already check all the settings and they are the sa...

Despite a couple of hours on CCO, I can't find a list of skinny-supported IP phones. Can anyone point me to one or tell me from their experience?Thanks in advance,Stuart Smith

DND button cannot be used because it is grayed out on the display. Have checked the DND settings - have replaced all settings but still problem is present. Have reset the phone and problem still persists.

Customer is using PA (1.4(5) ) for speech services only. When the customer dials the pilot point to get to the speak by name directory, the system will say "Extension XXXX" or "JOe Smith" (the calling extension or name" before it gets to the PA gree...

Hi Guys!Does anyone know if ATAs support auto answer? I am trying to hook up a PA system to it, and I need it to answer automatically.Regards,Dragi

I am developing an XML application that needs to retrieve the Department information stored in the Global Directy of CCM. I have pulled many tables and cant seem to find where it is. Pleae help!

I have several sites connected into a Metropolitan Optical Ethernet (MOE) backbone. Our main campus is connected at 1000MB speed and other sites are connected at 100MB speeds, although all sites are physically connected via fiber gig ports (the prov...

I have a Call Manager 4.01 Sr1a implementation with approximately 55 7940/7960 IP Phones. They are connected with 2 3560 48 port inline power phones, a 3550 24 port and then a 3750 24 Port Gigabit switch. I have a voice and data vlan with all the v...

HiMy company is soon going for a internal IP phone syatem. The edge switches will be 3750G-48PS and core is a 6500 with dual 720 Supv. The phones connect to the edge switch and the PC's connect to the phones.Here is the question.I wish (Need) to use ...

we've configured multicast MoH and enhanced conferencing at a branch router with SRST as described in the documenthttp://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/vvfax_c/callc_c/ccm_c/intcnf2.htmas i can see in the following s...

Hi folks,I have to add the SRST configuration to a running MGCP gateway (2621XM ver12.2(15)T11) with two Callmanager 3.3(3). Do I have to add this? Is something missed? (I also post the running-config)dial-peer voice 10 potsapplication mgcpappincomin...