Other Collaboration Subjects

Maybe someone else have had the same problem. I have a Cisco CallManager 3.3(3), a 3725 router and a 3524 Switch PWR. Everything is working fine, I just installed and configured everything, BUT, for some reason when someone call from outside to our p...

What do people think of CCM4 so far? We are quite eager to upgarde because of a couple of the features but have been burnt in the past by immature releases of Call manager.Thanks,Peter

Hi, I'm installing 4.0 in my lab and all I had handy were the 2000.1.2 OS CDs, then I installed 2000.2.6 directly instead of install 2000.2.5, plus SR8, then 2000.2.6. Anyway, 2000.2.6 installed fine, when I went to kick off 4.0, it errored and sa...

HI, Is that all devices (IP Phones, gateways, media resource...etc) should be registered on the Subscriber CCM? Or some devices need to be registered on the Publisher?Thanks for your help!Regards

I'm adek from indonesiaI want to upgrade the cm from 3.3.3sr4a to 3.3.4 but it come out with this error "Failure occurred trying to determine if Cisco Directory install succeeded.Aborting Cisco CallManager install", Any idea how to resolve it?ThanksA...

Hi. I'm wondering, if I have a nested service policy under class-default, do the configured class-default features apply to the traffic that matches classes within the nested service policy? That is, are the class-default features (marking in parti...

I was updating the firmware on an ATA 186 when the power dropped, which rendered it comatose. I copyied the eeprom over from a working unit and it now works fine, except it also adopted the mac address of the other ata. Is there an easy way to chan...

Hi All,In callmanager (I use 3.2), I can add gatekeeper trunk in two types: h.225 trunk and intercluster trunk. But what's the real difference between them? I still can connect 2 callmanger even I use h.225 trunk? What features do intercluster trunk ...

Hi NetPro,How to check what firmware version in the ccm 3.2(2c) ?Thank you in advance,Regards,Jackal

Once upon a time, two 7970 phones with a shared DN would indicate, with a red light on the line button, when the other phones was using the line. Now it does not. It works fine on my 7914 side cars. I setup two new 7970 phones as a test and, sure eno...

Hello,Does any one know why do we have to program a VoIP dial-peer when we are doing H450.2 transfer either in SRST or CME.Thanks in advance.

Hello,how many telephones can be registered at the same time at a CCM.If one of my subscriber failed the phones will be register themself at the other subscriber.how long does it take?I need information to calculate the registration-process for more ...

Does anybody know pak abort mean in the show voice dsp. I saw pak abort in DSP2 in 2651 router with is-mz-12-3-6.AIM-30/VWIC-T1 module. I experienced dead air sometimes when calls from PSTN to the IP phone.I think I may run into a DSP issue. Please s...

Hi,I have a question regarding HSRP on Voice gateways.I have two 2620 XM with ISDN PRI connected to both of them 30 channels on one and 20 channels on the other.They are both also used for DHCP and VLAN routing.i have the Callmanagers and Phones in o...