Our ip address scheme was changed here in our office and since then the Call Manager Service and many others won't startup.Any ideas why this would happen?
I'm upgrading a customer with <100 users from the ICS7750 to an MCS platform. They only need 100 users so the 7825 is the right size. However, they want scsi raid(1). The 7825 with scsi raid is specified to be used only for Unity. Can anyone tell...
I have a 1760-v running on 12.3(7)T, .Connected to pstn by Vic2-2bri-NT/Te .When I am in srst , a incoming call by bri to an ip phone (7920) is connected , but there is one way voice .The calller on the pstn network does'nt hear what is said in the ...
When you use Regions & Locations to determine CAC (Central Site Call Processing example; G.711 for within a LAN location and G.729a between all locations via a WAN) does the Call Manager handle the codec selection and then notifies each end station o...
I would like to make calls from an FXS port on a 1750 to a PBX via a 3660 with an E1 card. I have set up the routers so that if a caller on the FXS port dials destination pattern 300, he will get dialtone from the PBX connected to the 3660 at the fa...
I can't seem to find out how to translate inbound calls into CME from the H323 network. You can use translation rules on the ephone-dn but that is only applied to calls made from the ephones. I need to send digits to the CME, translate, and then pass...
To ALL, I have imported about 400 sets thru the BAT tool and it seems that none of the sets were associated ...Device Association- When users login to CCM on the webpage, devices are not associated to each individual and they can't setup speed dials ...
Hi everybody,As the title describes it, my needs are not very specific.In fact, in order to work on different projects, I need tools to developp IP telephony applications which will work on Call Manager and IP Phones.I know that I can use XML, ASP, P...
Anyone familiar with locating PRI errors on a Catalyst 6000? The only command I can find is show port voice fdl which seems to give some error information. I'd like to be able to monitor any circuit disconnects. I've set up syslog as well, though ...
Hi,I have a 2600 router with two VIC 2Fxs cards on it. I have created 4 pots peer for the same. The problem is when I make a call from one Fxs card to another there is a lot of echo being generated. If I call another extension within the same card th...
I have a customer who is having trouble with 7910 not registering.They have two sites Callmanager 3.2 and 3.3.At both sites the occasional phone will become unregistered.To fix this they have to go into the switch port config and shut the interface t...
