Other Collaboration Subjects

I am to setup some Mitel ip phones. They will be on 3524XL switches and a seperate Vlan to the data, connecting back via a 802.1q trunk to a 4006 core switch with the Mitel switch going into a port on the 4006. I have setup the ports on the 3524XL t...

I have a 2650XM router with CME license. The 2650XM, however, does not have a voice module for PSTN connection. I do have a AS5400 with ISDN PRI for voice. Can I have the CME router use the PRI connection in the AS5400? If yes, will that be H.323? I ...

I have a customer who wants to monitor CPU Util and other server performance stats with Network Insight. Is this supported on CallManager? They are running 3.3.3sr4a.

Can I Release IP Phone IP Address if the IP Phone is not registered in a CCM and also the DHCP server does not show the IP phone IP address?

I have CM 3.3.3. The site took a power hit and came up. About 30 minutes later I started seeing the below errors in the Event Viewer, App log. There are 4 separate errors (only the ParaNameInfo: field changes) and all 4 occur at the same time at f...

Our ip address scheme was changed here in our office and since then the Call Manager Service and many others won't startup.Any ideas why this would happen?

I'm upgrading a customer with <100 users from the ICS7750 to an MCS platform. They only need 100 users so the 7825 is the right size. However, they want scsi raid(1). The 7825 with scsi raid is specified to be used only for Unity. Can anyone tell...

I have a 1760-v running on 12.3(7)T, .Connected to pstn by Vic2-2bri-NT/Te .When I am in srst , a incoming call by bri to an ip phone (7920) is connected , but there is one way voice .The calller on the pstn network does'nt hear what is said in the ...

Can anybody recommend a PSTN simulator that support PRI /CAS/FXO ? We want to build a voice lab. thanks a lot.

When you use Regions & Locations to determine CAC (Central Site Call Processing example; G.711 for within a LAN location and G.729a between all locations via a WAN) does the Call Manager handle the codec selection and then notifies each end station o...

I would like to make calls from an FXS port on a 1750 to a PBX via a 3660 with an E1 card. I have set up the routers so that if a caller on the FXS port dials destination pattern 300, he will get dialtone from the PBX connected to the 3660 at the fa...

I can't seem to find out how to translate inbound calls into CME from the H323 network. You can use translation rules on the ephone-dn but that is only applied to calls made from the ephones. I need to send digits to the CME, translate, and then pass...

Anybody which one of the following prorvides DNIS on T1?E&M, loop start, ground start? thanks

To ALL, I have imported about 400 sets thru the BAT tool and it seems that none of the sets were associated ...Device Association- When users login to CCM on the webpage, devices are not associated to each individual and they can't setup speed dials ...