Other Network Architecture Subjects

Can the dialer0 interface in the configuration below get a dynamically assigned address ? Is there a special interface config statement for this.Radius server is all setup to allocate addresses from a pool and works to other vendors' routers.interfac...

C3550 has joined the OSPF network and planned to use policy route to control the traffic for two redundancy WAN links.

Good Day,I have a 2600 router that I am running NAT on. (well PAT actually )We access an Oracle server running on a SUN box on another network whose IP address space conflicts with our own. Thus, we need to run NAT between the two.lWe are translat...

I am very confused. I am configuring Policy Based Routing and am using the"set ip next-hop ip_address"" command. Does the ip_address I specify have to be from an adjacent router (i.e., on the same LAN or WAN attached 1 hop away) or can it be from a r...

(take into account that this isn’t a real-life case, it’s just a lab practice)This is the case:· I used part of the “CCNA 5 router scheme”.· 1 Router Cisco 2514 (A) with “no ip routing” set.· 1 Router Cisco 2501 (B) with “no ip routing” set.· Both ro...

how do i remove a IP alias ip address? thank you.

We have remote sides connected to central with 128K leased line on cisco router 2600. How can i restrict the bandwidth usage of all protocols except smtp?For example users can use 20K of bandwidth for applications other than smtp.Thanks

HiI have a query on the logic of functioning of this command.router(config-router)#distance 150 0.0.0.0 255.255.255.255 10(I am firing this command under the IGRP routing process)If the above router has both IGRP and RIP running and if RIP is being r...

We are having a routing issue on our office 2621. I have configured the router to nat the local office subinterface F0/1.15 network out through a Cable modem connection E1/0. I have the a number of servers sitting on a subinterface of the router f...

I need to compare potential throughput of the following linecards with a Sup2:-6148-GE-TX / 6548-GE-TX / 6516-GE-TXAs I understand it :-6148-GE-TX - A classic module with a single connection to the standard 32Gbps shared backplane. It can participate...

I have some troubles when an interface have an ip address secondary that overlaps with primary ip address, eg:primary 10.10.0.1 /16secondary 10.10.10.1 /24The router running OSPF only advertises the network configured in secondary ip address (network...

I have installed all these components on my management/monitoring server. They each seem to want to use syslog for various functions.How do I change the syslog destination port on IOS routers.How do I change the listener for 2 of the 3 components li...

Our main 6509 needs to be powered off for a bit after 3 years of uptime.Besides saving the configs on the MSFC is there anything else that needs to be considered before shutting it down?