Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

“Webinar

 
Labels

Forum Posts

Start a conversation

Default Routing vs BGP

Hello,I have one problem, We have configured BGP on Cisco Switch 6509E, firewall module on the switch is making nat for all users,but users is not going to internet yet, I do not know hot to configure 6509E to give internet access to users.If I route...

How is Tunnel Transport MTU Calculated?

I searched this support community and Cisco in general and can't find and the answer. Here is my scenario.A dialer 1 interface set to mtu 1472A fastethernet interface set to mtu 1472 in the dialer 1 pool.A GRE IPSec tunnel 1 that uses dialer 1 as its...

GRE TUNNELS ON 2921

Hi cisco kids,can somebody please tell me  what is a maximum number of configurable gre tunnel interfaces on CISCO2921-HSEC+/K9 router?

Adis Cato by • Level 1
  • 1705 Views
  • 2 replies
  • 0 Helpful votes

Resolved! feasible successor issues

HiThis is related to the post I made earlier but was about trying to get a route-map to work, if you see the output belowspct-hbroughton-sw1#sh ip eig top 172.16.190.0 255.255.254.0EIGRP-IPv4 Topology Entry for AS(90)/ID(10.202.146.66) for 172.16.190...

ktwaddell by • Level 1
  • 813 Views
  • 4 replies
  • 0 Helpful votes

Resolved! Wrong system software for this hardware

i'm new to cisco router, recently i accidently remove the CF memory card from running cisco router, which result cisco goes to rommon mode with and can't start-up. here is the details error ,System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1...

CAT6500/SUP720-3BXL IOS Query

Hello,I've been trying to track down a particular feature on Cisco's Feature Navigator and have come up with a question, is it possible to run a 7600 IOS on a SUP720-3BXL when in a 6509 Chassis?Fundamentally the Supervisor engine is the same and I co...

Resolved! Setting up Flex stack on 2960 switches

Hi,I have to setup my first flex stack and wanted to make sure I do it right.  I have the physical aspect of the stack down.  From what I gathered I have to setup the master switch as the highest priority and then provision the other two switches.  B...

jdave2780 by • Level 1
  • 3103 Views
  • 5 replies
  • 0 Helpful votes

CBWFQ - Antivirus Traffic

Greetings,We are currently running CBWFQ with the below policy in place. One of the goals behind the policy was to try and create a less-than best-effort (BULK-DATA) class to put AV traffic into. The AV traffic is being marked appropriately and is hi...

Policy-map question

Hi, I'm trying to resolve an issue with phones on remote routers thet keep re-registering throughout the day. I changed the:policy-map shaperclass class-default    shape average 2000000  service-policy voice_and_videoTo:           policy-map shapercl...

4G modlue for 2951

  Hi,          What are my options for using/installing/configuring a 4G card on a 2951 for a redundant back up solution? Is the module slot with the sim card the only way to deploy it?Any good docs on the install?Thanks, Pat

Routing Issue - IPSEC Tunnel

Hi AllNot sure if this is the right way of configuring IPSEC VPN Tunnel, I feel of having routing issue on IPSEC Tunnel. On stopping Tunnel and Internet interface all is OK.My scenario is following Sales Office 1  & Sales Office 2 are in same country...

cisco 1841 two ISP redudancy problem

                   HiWe have cisco 1841 router with two ISP . But we facing the problem whenever our secondary ISP Link goes down the Primary has also went down.We have only one default route for primary Link Can anyone give solution for this

Resolved! EIGRP Route-map stopping redistributing

Morning All,I've added a router-map on my back-up L3 3750 (B) switch which has a link to main L3 3750 (A) and a link to wan cloud running EIGRP on both links, I put a route-map (see below) to set the metric on all EIGRP routes, when I shut the main l...

ktwaddell by • Level 1
  • 1309 Views
  • 7 replies
  • 0 Helpful votes

Resolved! cisco router 1841 and asa 5510

we have cisco2841 router and asa5510they have connected in the following wayin the above scenario we got the two subnets of ipaddresses from ISP   pubip/30 and pubip's/29 ....my doubt  is ..because everything is done in ASA 5510 firewall why do we ne...

veeru.pvr by • Level 1
  • 1357 Views
  • 4 replies
  • 0 Helpful votes
View All
Review Cisco Networking for a $25 gift card