Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi,I'm trying to establish a second connection to a different ISP using a single ATM/HWIC-ADSL Line as per this document: http://www.cisco.com/en/US/docs/ios/12_4t/12_4t15/mpppoec.htmlThe router is running Cisco IOS Software, 1841 Software (C1841-ADV...

I'm having an issue with the remove-private-as community.  We have a Customer who is dual homed to two of our routers and they are using a Private AS number.  When configuring my bgp session to them, I added the neighbor x.x.x.x remove-private-as but...

Resolved! multilink ADSL

Can anyone help? I have a requirement to provide 2ADSL connections to a small network. I was thinking of putting in a 1921 router with 2wic-adsl cards. Is it possible to multilink these 2 circuits together?Sent from Cisco Technical Support iPhone Ap...

tpaprotny by Level 1
  • 966 Views
  • 2 replies
  • 0 Helpful votes

We are a new medical school located in PA. Just have just completed a new building and are now working on getting our network finished. Here is the situation we have a 50MB Internet Connection that comes into our network that then hits the ISPs Cisco...

Hello,The topology I'm currently working on has an ASA at the edge (plugged directly into the ISP equipment) with a 3750X stack behind it. The 3750X has an NLAN interface for internal routing between multiple sites.The 3750X has a default static rout...

Hi all,By default, ospf will send 4 hello packet for every ten seconds, if there is no reply within 40 seconds, this ospf will be declared as down. If I want shorten the ospf time. Let's say, I want to declare the ospf neighbor is alive or not within...

acbennyma by Level 1
  • 913 Views
  • 2 replies
  • 0 Helpful votes

Hello,I have a Cisco 1811 with both WAN ports setup.  Static routes for both on the router as well as route maps behind to support the individual vlans.  My problem states here.On one port, which is a standard DSL to backup the office network, everyt...

Dear all,Does Cisco 3750 ip sla can monitor, let's say, monitor 3750 G1/0/1 port status, once it is down, then 3750 also make G1/0/2 also down. If yes, what is the command to do it?

acbennyma by Level 1
  • 930 Views
  • 3 replies
  • 0 Helpful votes

Hi allI've been searching for a way to have the router check the status of the dialed and if it's not responding and or down to have a TCL scrip reset the interface.Is this possible?Sent from Cisco Technical Support iPad App

Resolved! Need HWIC

We are converting from integrated T1 to dynamic with ethernet hand-off.  We have a T1 CSU/DSU card installed on our 1841 router.  I think I need a HWIC to handle the conversion.  However I notice on the 1841 I also have 2 lan ports.  Can these be set...

rlenz by Level 1
  • 868 Views
  • 5 replies
  • 0 Helpful votes