Dear Expert,Please help me to solve this problem,I had Cisco Core Switch 3560 and Cisco access switch CE500 and i did Vlan(Vlan 10,11,12,13,14,15,........)so i want PC on Vlan 13(IP:192.16.4.2 can access to other swith and other Vlan)Please see in th...
Please i just got a small contract to take like 20 systems to the internet.I am using a VSAT link, a swicth and a cisco router. The router is configured for nat overload, and there is a dhcp server on the LAN. My question is, the computers are not go...
hi, i have setup easy vpn server on ASA 5550 using ASDM. i have configured it using VPN wizard, my vpn client connects to the easy vpn server but cannot access inside network which is on inside interface of ASA. i can ping outside interface but cann...
Has any one configured this as need to load balance across the 2 interfaces, have own APN to set this up on but unsure if carrier would accept as using different sim cards.Any ideas input would be great, thanks.
Bonjour,I know that the PDH technology is not very up-to-date. I just want to have elements of you about the justification mode that is generally used.G.742 describes the positive justification for E2.G.745 describes the positive/nul/negative justifi...
Hi all, Not a difficult question if you know - but i don't so i thought that i'd ask :) When calculating frame-relay TC what is the formula? I'm getting conflicting information. Is it: tc = bc/CIR tc = be/CIR tc = CIR/bc (or be for that matter) I...
guys we have a rockwell ACD (PABX) which is connected to a cisco 2821 router via E1 card....the router is connected over WAN to a IVR server and the communication is SIP based. the router works perfectly but sometime we get calls from gusy who use PA...
Dear All,Which one of the following is suitable AND BEST command for HSRP MD5 Authentication.standby 1 authentication md5 key-chain ORstandby 1 authentication md5 key-stringRegards
Dear expert,Good Day.I have a question about the PPP multilink.Currently, i have 3 serial interface and bound them as multilink 3. But unfortunately serial0/0/0 has error increasing and rest 2 serial are normal.My question is why #show int multilink ...
Hello,I have a STM1 link connected to the 4-port POS-OC3-SM-IR+ module.Can I know how to do test the link? Just a normal ping test? Is there any preferred ping test pattern to test the link stability?Thanks
Please find the attachment for the network diagram. MSAN is connected to the layer 2 access switch SW3. SW3 has two uplinks, one goes to SW1 and other goes to SW2. SW1 has the uplink to one of the PE and SW2 has the uplink to other PE. MSAN provides ...
Dear team, I am not able to commission 2mb mpls link on Channelized E1/PRI port. i tried with config arecontroller e1 3/0channel group 0 timeslot 0-30------interface serial 3/0:15ip address x.x.x.xencapsulation pppthis is the configuration i made on ...
Hai, Iam having a network cloud which contains the protocols like ospf ,ibgp ,eigrp,rip are running in all routers and the routers are in the mesh connection.So my question is which all databases it conatains like ospf topology table,ospf neighbor...
