If I have 15mb of bandwidth from my provider, should I enter my full 44210 rate on my interface? I do belived that the partial rate should be handle by my provider.
Hi,A 1700 router, ver 12.3(22) does not accept the following commands under int s0 . Any suggestions would be appreciated to configure the router.Thanks.service-module t1 clock source line service-module t1 data-coding normal service-module t1 framin...
Hi, I would like to configure a Multilink between 2 sites. My question is how many E1 can I bundle on the same Multilink. Does a router 3725 support 4 E1 on the same Multilink,the same question for a 2811 router?Thanks regards
I have 2 new T1 circiuts installed for a point to point connection between two offices. I have not worked with a cisco router in quite some time. The topology I have now:Office 1 network = 192.168.100.0Office 2 network = 192.168.200.02*T1 = 3.0Mbps P...
I have an 1841 with IOS 12.4 connected to an isp with a single subnet - I am trying to create and access list for IP phone access to a single internal IP on ports: 5566 tcp5567 udp6004-7039 udpI can nat the first two with static entries but I cannot ...
I've been wracking my brain on how to enable dot1q on the 2 fastethernet ports in the chassis of the router. No layer 2 networking modules are installed, anyone have any ideas?
Hello,im trying to get a back to back connection over 2 VWIC-1MFT-E1 between 2 routers. Cabling is correct. I have CD on both ends. One end is set to clock source line the other one to intenal. It controllers stay down and i see CRC's indicating cloc...
Hi,On the following web page http://www.cisco.com/en/US/products/ps6566/products_feature_guide09186a00801a7f7a.html#wp1027188 there is something I can't understand concerning the BGP route-map continue command.With this configuration:route-map ROUTE-...
we have restarted 3745 router , we are not able to access it through console as well not getting connected in LAN.We used control break also.Till hyperterminal screen is blank.
Hi,I am facing reverse routing issue , where in traffic on oneside is going to one route and return in different route. This is happening on one of the Core Router of our network.Apprciate your ideas on this with possible Route Cause description..~A...
Hi there, i have a high cpu problem in cisco 7609. I have excluded the ip.21,ip.22 and at to stop the nms from polling the router, but the high cpu load still goes on. I have sniffed a huge number of get-request from some NMS and seems that the check...
