Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

MGX

Present setup We are having 2 DS3 circuits from India to US. One DS3 from India to Alpharetta and another DS3 from India to Cincinnati. Presently, whenever ether of DS3 links goes down the other will handle the voice and data traffic. Proposed setup...

Resolved! T1 Problems...Very bad ping times from Router

Hi Guys, Just wanted to ask for advice regarding the the following problem. I have a T1 line for data to AT&T. The interface is up and and line is up. However, I am getting intermitten ridiculous ping times to my 1st hop AT&T gateway. It's causi...

tomtom001 by • Level 1
  • 1669 Views
  • 4 replies
  • 0 Helpful votes

MGX : Voice Call Drops

Hi Could any tell me whats the meaning of this alarm which i observed on my MGX .08A70237 08/17/2006-06:40:18 PNNI-7-PNNI_INFORMATIV pnPnni pnni_log PnNet/PNNI/pnni_delete_summary_address - summary address not exists08A70236 08/17/2006-06...

cisco by • Level 1
  • 694 Views
  • 3 replies
  • 0 Helpful votes

Use DR Internet when HQ is full

Is it possible to configure users on the internal network to use the DR Internet connection when the primary connection is full, or some percentage of being full?At the moment we have the default gateway of the users as a dynamic route learned from t...

Artificial Intelligence

HiSorry, I know that this is not the appropriate forum, but I know that you can show me the way ahead.I am developing my work for completion of the course of Engineering and I will make on application of artificial intelligence (neural networks) in r...

T1 Wan interface question

Here is what I have:rtrCore--rtrT1Core--T1rtr--SWIf I ping to the t1 interface on T1rtr, I get horrible response. It will reply, reply, request timed out...no real pattern, but over 50% of the packets are lost. If I ping to the Lan side of the t1rtr,...

ccie preparation

Dear guysi wnat to prepare my ccie lab1)which books i should read2)best simulator for practising lab3)which desktop to buy for support simulator4)how many equipment can i use in one desktop5)how many hours per day6)is there any books or sites which...

serial is down line protocol is down

I have connected two 2600 routers back to back using DTE/DCE cable. I have set the clock rate 56000 at DCE end. I have also assinged IP addresses to the Serial interfaces. But when I connect them I get this message 'serial is down line protocol is do...

destination NAT

! want to NAT 3 destination ip addresses to a single 1 address so that the requests coming for 3 ip addresses are translated to 1 ip address.

PBR Questions

Hi,I am working on a network design that could possibly use alot of Policy based routing and wanted to check a couple of points. the network will soley be made up of 6500's and with SUP720-VS's.1)Can multiple policy maps be applied to different inter...

Load more