Routing

Hello all,Can you help me to choose the good Cisco Router to do ISDN in Bahamas?Does I need Cisco 802 or 801 ? I think the switch type is Basic-ni but really don't sure. Is the NT1 is including with the Cisco 802 ?Many thank for your help.

We have 2 headoffices in the different cities.In each city we have connections to Providers collocation where we have Cisco7206.All 4 routers (Cisco7206) connected with each others via PLC.We have a very critical and high bandwith traffic between HO'...

Hi,Anybody knows the maximum interface speed of module WIC-2T ? It will be installed in HWIC slot of 3845 router.Where can I find this information ? (2, 4 or 8 Mbps)?TIA

I have 2 ASA's connected to 2 ISP's. One with default originate metric 1 and the backup with default-originate metric 5. how do have one specific network use the backup as a primary? Lets say I have 10.0.0.0/8 use primary but I want the specific 1...

If I wanted to add a backup Cable modem internet connection to my 2811 router that is currently running a 10 megabit ethernet handoff on its Ethernet WAN card, can I just add it to one of my ethernet ports?One of the ethernet ports is used for the in...

Can anybody pl. give give me link of layer 2 access list commnand list to find MAC address?Please help me to find it.

Ok, I have a 2821 router that has a username and password. I thought I knew what they were, but apparently not. I even get prompted for them in Rommon.

i'm facing a telnet issue. I have a cisco 3560 switch and a voip gateway vg224 connected to port 6 on vlan 3 (10.1.30.1) of the switch. i'm able to ping the gateway from my laptop that is connected to port 24 on vlan 1 (10.1.110.1), but when i try to...

Hello, I really need help here. Over the weekend i tried to Migrate but failed so had to backout. Any input will be greatly appreciated. Following are my changes which didn't work. I have a router Montreal:interface FastEthernet0/0ip address 16...

Is there a proper way to load-balance 2 unequal costs T1 links without using the "variance" command, assuming that all routers are running EIGRP.Thanks.hieu

I'm searching command list to find MAC address on cisco.com site.It showed me one link where I'd get command list ..but it seems something is wrong with that link..that link is -http://www.cisco.com/cgi-bin/Support/Cmdlookup/home.plCan anybody fix it...

I'm using GTS (Generic Traffic Shaping) on interface (I would like to limite trafic to 2MBps), and I would like to configure WFQ, which is the default algorithm working with GTS. But I can't succeed to configure the size of the queue. Do you know how...

HiMy customer has a 1841 with HWIC-1ADSL installed. Interface stays down/down when I connect the DSL line.T-com uses Siemens DSLAM which is not in the list of supported DLSAM see table 1:http://www.cisco.com/en/US/products/ps5853/products_data_sheet0...