Routing

i just noticed but doesn't know the answer to this question. why does the last packet in a traceroute always times out ? thanks.Traceroute output:Router#tr 192.168.1.254Type escape sequence to abort.Tracing the route to 192.168.1.254 1 192.168.1.254...

I had next configuration of 2811 router-interface Serial0/1/0 description ###Port to MPLS 384 kbps ### encapsulation frame-relay load-interval 30 frame-relay interface-dlci 16 frame-relay lmi-type ansi service-policy output VoIP!policy-map VoIP class...

Hi, I am trying to set up a 1721 router with an ADSL line in the uk. I have the details from the ISP as:VPI: 0VCI: 38Protocol: PPPoAModulation type: vcmuxAuth Type: CHAPIP Range: 80.x.x.185/29I have looked at the ADSL example configs at http://www.c...

Any reason a 3640 with an NM-A1-T3 couldn't handle a ds-3 circuit? We have a 10mb pvc on it which I believe can burst upto the full ds-3 speed. We seem to be losing UDP packets at the application level at a rate of about 5-10 per minute under stead...

I have a 2821 router, with the following boot statements :boot-start-markerboot system flash c2800nm-entservicesk9-mz.123-11.T7.binboot system flashboot-end-markerIn flash I have the following images :1 26725176 Dec 14 2005 10:00:34 +00:00 c2800n...

Hi thanks for your attention. I config policy-based route on 3750 just like this : no aaa new-model switch 1 provision ws-c3750-24ts vtp domain vtp-a vtp mode transparent ip subnet-zero ip routing ! ip dhcp pool vlan1 network 192.168.0.0 255.255.255....

Hello,I'm have Cisco 871-K9SDM version: 2.3IOS version: 12.4(6)T2In the URL Filtering section router says:Application Firewall unavailable.The IOS image in your router does not support the requested feature. To configure the feature, you need to go t...

Hi,Can someone pls let me know how the cisco WCCP works ?Did some searching ,but didnt get much info.thanks in adavnceThomas.

Hi we are going to implement firwall security C515 on our techncal centre , i need some doc for this plz send us some link for for this.Thanks

When trying to send an e-mail from the SMTP server on the DMZ to the mail server on the inside network, the mail is not delivered. Is this due to the fact that the firewall can not route the message to the mail server? If so how can I get around this...

Hello guys,On my NAS there is a NetFlow collector (ndsad). And because NetFlow is sent via UDP, some info on traffic may be lost. RADIUS accounting is not good for this purpose too. If the channel is not stable enough, how to pick up statistics from ...

Hi,We have a connection between our border router and the gateway firewall through the router's ethernet port and a connection to our ISP host through the router's serial port. The serial interface is fine but the ethernet interface shows a lot of co...

I just started with a company and trying to improve performance across 7 pvcs in a frame-cloud. I have a 3845 with a bonded 2xT1(3088mbps) connection into frame cloud. The 7 remote sites connect into the frame cloud at varying speeds T1, 768, 368, th...

Does a full point to point T1 line transfer at 1.5 MBPS full duplex transmit and receive simultaneosly?So in other words can you transmit 1.5 MBps of traffic while you are receiving 1.5 Mbps at the same time on a T1.This guy at this service provider ...