Routing

can’t understand how to calculate Normal Burst and extended burst from the formula: normal burst = configured rate * (1 byte)/(8 bits) * 1.5 seconds extended burst = 2 * normal burst" That’s what I did, If some one can help me that I am doing it corr...

Hi,I am using 2 ISP's to connect my network with internet.i have put routes like..0.0.0.0 0.0.0.0 isp1 next hop ip0.0.0.0 0.0.0.0 isp2 next hop ip 50The problem is..When my isp1 is down..then i am not able to access router from my home..there is no a...

Hi, i´m installing a router 3810 with to serials interfaces which are using a point to point frame relay circuits each one, my routing protocol is RIP and i will change to Eigrp 10, anyone know how can control that only the HTTP traficc acrooss to th...

I would like to learn how to setup a network using a Cisco router, firewall, and switch. I would like to know what anyone thinks about using a Cisco 827 ASDL router,a PIX 506e Firewall, and a Catalyst 2950 switch to get some hands on experience. I ...

Hi all,I am trying to configure a GRE tunnel between a 2651 Router and a Satellite Equipment which supports this Protocol thru satellite link. First of all, what i could observe is that my tunnel is established, bcos when i trace from my PC connected...

Hi,Looking for sample configuration for router.I want to block workstation mac-address to access network resources."Extended Access-List"RegardsMeer

I would like to create an EIGRP neighbor relationship between my inside router and my Internet router. There's a PIX firewall in between the two routers.Any idea if this is possible?Thanks in advance.

Hello all,I have a 3745 Router with IOS ver 12.3(7)T and I have another Router (2621 model ) which have a card with 10Base T/AUI port .Will this card work with 3745 Router with IOS 12.3 (7) .Thanks with regards,Raju

Hello, I have 2 main offices and several branches. Plz take a look network diagram in the attachment file. The Internet connection come through the HQ to Telco and Telco continue providing to others branches at the provices. The questio...

Dear All,Is it possible to traffic shape Frame Relay PVCs that are switched between interfaces.I have a router with Frame Relay PVCs that bother terminate on an interface and others taht are switched throughto another interface. We have shaped the PV...

A Chairde, Have 7609 with IOS IOS (tm) s72033_rp Software (s72033_rp-PSV-M), Version 12.2(17d)SXB5 on it. Am trying to setup BGP Graceful Restart , but option not available in ROUTER BGP layer. Prereq. IOS is 12.2(15)T , Link...

I have read in http://www.cisco.com/en/US/products/hw/routers/ps368/products_installation_guide_chapter09186a008007c8bc.html#wp1098824 about required power supply for Sup720-PFC3BXL, but I don't know exactly I should use which Power Supply( 2500W, 30...

Hi Sir,My customer is trying to implement both their HQ and branches to communicate via a WAN (Leased line) link but at the same time wants to maintain the VLAN information once across WAN. Just want to confirmed which is the best solution for this.P...

I need to find out if the 1711 and 1721 routers can be setup with a secondary VPN tunnel (or crypto map) Right now they are all programmed with the crypto map that points to our current IP address of the firewall. When we move in 5 weeks, we will ha...