Switches - Small Business

Hello, I have sample lab    dhcp-client  ------- (vlan62) sg-300 switch  (vlan62) ------ dhcp serverWhen I set on switch :dhcp relay  : enable option 82 : enable dhcp server address: ip of dhcpWhen debug packets from client to server, there is no 82 ...

                   I am trying to use a GS200-08Ev2 switch to snoop data (Tx and Rx) from a network used to link secondary computers to a master computer for tool control.  The secondary computers connect to a central switch (SG100D-08).  That centra...

Hi!!I want to share with you a problem that I found on this switch (Firmware is 3.0.2.0)1) After i saving DHCP Relay Settings i reboot the switch and the settings are not saved, all others settings are ok but DHCP Relay settings are lost after reboot...

We're running a cluster in multicast mode as a  loadbalancer.We have Cisco SF300-08 and when we adding a static ARP entry results in an error message telling the user that the hardware address needs to be a valid  unicast MAC address.So how to setup ...

Hello:I have a Cisco SGE2000 and suddenly every port stopped linking, no power light on but Stack ID lights are turned on (except number 3) and 4 Gbic ligths are on and the fan is fully working.I tried to reset to factory default with no success. Can...

We recently purchased a Cisco SF100D-16P for the PoE functionality to power 6 SPA504G phones.Previously the office had only 3 phones and they were using wall wart supplies but when the new phones did not come with supplies we decided to go PoE instea...

I am trying to create routed ports in SF 300 small business 8 port switch.I have 3 different LAN say 192.168.1.0/24, 192.168.2.0/24 and 192.168.3.0/24I have 3 unmanaged linsys switch where I have connected all these computers.Now what I have to do is...

I am experiencing an issue I can't seem to get a grasp on.  I have VLANS being automatically configured on my switches and can't determine why this is happening.  I hope I provide enough information below, any suggestions on what could be happening h...

we are planning to buy 8 port POE switches, but from the market we foud the following models are available. one is costly and the other one is less costly. cheaper. SRW2008P-K9-EU  is the costly model.SRW2008P-K9-AU is the less cost model. but we are...

Hi all,I have a SG300-28 setting on L3 Mode, and it VLAN1  IP is 192.168.218.3 255.255.255.0On top of this, have a router, it LAN VLAN 1 IP is 192.168.218.1 255.255.255.0When I login on the SG300-28 Administration > Ping or Traceroute, it never pass ...

Hello friends.This is my first time here so please give me the hope I need .I am the new sysadmin on my work but unfortunately the last sysadmin didn't make any documentation about the actual infraestructure so i have a big problem.Now I have two swi...

Is it possible to configure a cross stack etherchannel between 2 SG500 (in stack) and 1 SG200/SG300?