Switching

I have a Cisco ASR 1001.  I am trying to send traffic from g0 to a switch that picks up all my logging traffic.Below is my config.  What am I missing.  I am trying to send traffic to device 10.10.23.17. I want to make sure that ll traffic get to 10.1...

I have video encoders and decoders that I would like to setup for video streaming across Campuses. I currently have a vlan segmented for the video traffic. When testing the traffic doesn't reach the various locations. Everything worked fine when the ...

I executed "tdr cable-diag interface gi1/0/2" on my 3850 switch.Output is as mentioned below. Access point is connected to that port and it's negotiating 100M with switchport.Other AP negotiating 1g with switch. Does this output mean pair D is faulty...

Hello  I have 4 devices about the light system and these device connected cisco 2960 switch I can access these devices (ping ), after some time  I cannot access  I see "switch port up and connect on 2960 switch" if I use dummy switch these devices ne...

Hi Please see the below config, are these four commands making sense? Can we use one command to replace the four command? Thank you R1(config)#do sh run | i snmpsnmp-server community abc1 RO 1snmp-server community abc2 RO 2snmp-server community abc3 ...

cisco 3650 switch show us below log. what we have to do %PLATFORM-4-ELEMENT_WARNING:Switch 1 R0/0: smand:  1/RP/0: limited space - copy corefiles/switch-reports out of flash:core & crashinfo: directories. crashinfo: value 81% (199 MB) exceeds warning...

Hi,does the 2960X-Model support SD-Access and DNA?

We have a provider that has informed us they configured a MPLS circuit and we need to connect the networks via L2. I am at a loss as how I would need to accomplish this. Ideally I would like only specific traffic to be passed through the connection a...

Hi There, I am doing a HSRP project for two locations. involved devices:Dist: buic010-dist-aca01 | cumm111-dist-aca01Access: harr032-290es02   See attached picture. The current configured trunk link is from harr032 to buic010. We want to make redunda...

Hi, Do the vlans 1 and 1002 through 1005, falls in standard vlans category or extended vlan category. I know they are reserved but will they fall in standard vlans as they show up in the "show vlan brief" command. Please tell me. I got a related ques...

Hi   cisco press CCNP book says below lines for ip source guard, where i have doubt in that "The source MAC address must be identical to the MAC address learned on theswitch port and by DHCP snooping. Port security is used to filter traffic."   when ...

Hi,I have a 2960 with c2960-lanbasek9-mz.122-55.SE5.bin .I want to configure 802.1X for authentication of computers but i have no command authentication or dot1x in interface ...Someone have an idea ?Thanks,Best regards,Guillaume

Hello all,   we have a number of 2960S switches, connected in pairs, forming different stacks. We have enabled AAA. When using the console, we want to login using the local database. What we noticed is that when we connect through the console of the ...

Hi  i want to create NAMED ACL  to prevent quest network (in HQ office ) from access to servers in data centers except (DHCP;DNS ;Exchange) servers should be allowed  1- Quest network configured as vlan 50 ---- ip add: 192.168.50.0/232- DHCP SERVERS ...