I've seen some online command references documents that explicitly say how to create an object group for hosts/ports to be part of an ACL. However, the command "object-group" isn't available on my 5K platform. I'm running a Nexus 56128, version 7.1(4...
Here in the diagram below i should be able to do all communication from PC1 to the webserver using only NAT/PAT Concepts, but without using any of the routing protocols.
We are going to be moving our Datacenter to a Colo facility soon. We currently have our datacenter in a different building from our main staff connected by fiber across 2 gig interfaces in a port channel.I would like to limit the speed of this port c...
Hello,I have an ADSL fiber optic line coming from my ISP, I do not want to use the router of my ISP, then what router cisco then I use please? Knowing that there will be 3 L2 switch cisco after, that I want to connect to router by fiber optic
thank ...
hey everyone,
i have trouble when i want to connect ezvpn to my palo alto, i have setting my paloalto properly, but i dont know, does my router have support to connect my paloalto? when i connect to end device its working, but when i try to connect b...
Hi, I have noticed that our Cisco 2960-X switches have the IP Routing command. I was wondering how good of a layer 3 switch these are please? Does anyone use them as a Layer 3 switch at all please? Thanks
Dears,
I have a 4331 routers and I need to inspect http traffic but I don't get the keyword http ,, as seen for imap,pop3,smtp as per the screenshot attached which were seen in 2800 and 2900 series.
please find the attached screenshot.
below are the ...
Hi Team,
Please find attached layout I have 100,200,300,400 VLAN on SG500X L3 switch
On SG300 Switch on L2 Mode All VLAN replicate on L2 Switch nOw all VLAN communicate each other.
Please Guide :- I want to set all VLAN didnot communicate each other...
I have a catalyst 2960 series, ws-c2960-48tt-l with a bad image. I upload an image from the cisco website c2960-lanbasek9-mz.122-55.SE11.bin. When boot require user and password. Can't login
Regards
I have a wireless lab that i have currently working on.
I would like to connect my C3650 switches to my Verizon Fios service.
Can you please help with commands?
Thanks
I have router which is connected to a sg 350 switch.
The switch has vlan 10,20,30.
I have 2 pcs under vlan 20.
So, now using extended acl i want to block 2 pcs under vlan 20.
how to do this ? Please help me
I have 2x3850 switch in stack. One of the switch got removed from stack.
Current state of that switch is Removed.
Its running 03.06.06E.
I removed all the stack cables and reloaded ,shut down and connected stack cables again.But when it tries to syn ...
Dear All
I have a C2960S stack with 3 stack members. I have configured two vlans namely vlan1 and vlan2.
vlan1 having interface 172.16.2.11 255.255.0.0
vlan2 having interface 192.168.1.22 255.255.255.0
(Please note that these two vlans have differen...
Hello,
I have a question about configuring a new stack. Is it best configure the switches as standalone devices before connecting the stack cables and bringing up the stack? What's proper protocol? I've found a lot of literature about how to cable st...
