Hello All,How can i disable this vulnerability: The remote SSH server is configured to allow weak key exchange algorithms on cisco C3850-12s any help is more than appreciated! Thanks
Hello All,How can i disable this vulnerability: The remote SSH server is configured to allow weak key exchange algorithms on cisco C3850-12s any help is more than appreciated! Thanks
Do I need any kind of license or activation for the switch?
%PLATFORM_STACKPOWER-4-REDUNDANCY_LOSS: Switch 1's power stack lost redundancy and is now operating in power sharing mode I have a Cisco 3850 switch in a lab that only has one PSU installed. I am continuously getting the above logging message in the ...
HelloWe would like to control who can connect to our network.How do I create a list of ALLOWED mac addresses that are able to connect to our 9300 switches?Kind RegardsTony
Hello,I need help in finding out if 3560CX-12PD-S running Version 15.2(4)E6 supports BGP.(eBGP)
Hello all.I have a problem configuring my SG350 switches reasonably. The requirement is that both switches run two VLANs. VLAN1 of one switch should then together with the VLAN1 of the second switch make one unit.All information about the VLANs shoul...
Recently we upgraded a stack of 3650's. The upgrade process was successful and the switch elected as master booted as switch 1. The issue was that switch 1 had a confreg of 0x142 and not 0x102. In looking at other switches within the environment that...
I have a ASA-5516 connected to two Juniper SRX 345 Firewalls. I set them up initially connected through an unmanaged netgear switch at my desk, the IPSEC tunnels and VPN all worked correctly. However, once I put them in our Test-Bed and had to conn...
Hi All,Looking for a bit of help with a networking issue I’ve been battling with for a few months now.I have been trying to connect 2 different sites over a Wavelength unmanaged 10G single mode fiber connection. The fiber connects on both sides to a ...
Hello, I have two Catalyst 6880-X in a VSS pair that I need to upgrade to one of the suggested release. I don't have any FEX attached. I'm currently running version 15.1(2)SY6 and would need to go to either 15.2.1-SY6 or 15.5.1-SY1. I have a mainten...
Hello,My customer is looking for 48 Port POE switch which has Network Advantage, VRF and IP Base Features, Kindly advise
Hi ExpertsI am running a network with couple of cisco switches and Huawei switches, currently I had a Huawei Switch CE6810 which is root bridge and the mode is RSTP in both brandsI am facing issue with RSTP as Huawei is the root bridge and cisco is a...
I am really interested in the.. Cisco Systems ASR-920-24SZ-M ASR920 Series 24GE Fiber and 4-10GE ModI would be using it for large events with about 5 to 10k active clients. I already have a router that i like and im comfortable with and it is really ...
Edit: I was able to figure this one out thanks to another forum post. The solution is to use the request platform software package install command Hello everyone, I'm working with a new stack of 3650s and I wanted to install a newer IOSXE 16.x on th...
I will configure 14 VLANs in total. I will connect all Firewall Interface to one of the L2 Switch and I will cascade the other L2 Switches with that L2 Switch. In this case, do we need Trunk? Please check if any problem with such configuration.There ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
07-13-2024 07:22 AM | ||
07-10-2024 04:41 AM | ||
07-09-2024 08:16 AM | ||
07-05-2024 06:35 AM | ||
06-28-2024 01:20 PM |
User | Count |
---|---|
8 | |
8 | |
6 | |
6 | |
4 |