Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, November 4, 2024 through Friday, November 15, 2024. Our colleagues Rohit Chopra, Vaibhav Aggarwal, Anuraag Majumdar, Saquib Zeya...
Forum Posts
Hello all,I am trying to do a test of some thin clients internally at my office and I want to emulate T1 bandwidth on a switchport so I can get an idea of how they will perform at the other end of a T1 link.I have been using a policy-map to achieve t...
I had to configure several vlans on a CAT4510, all vlan had to see the server vlan. The customer dont want that one vlan see other vlans (only with the servers vlan). How can I do this?
I have a 6509 with a router module installed. On this router I have multiple vlan interfaces one for each subnet. I am adding a new subnet which I want to isolate except for outbound Internet access and specified functions between the subnets.the sub...
Ok,I am upgrading our switch to a Gig switch. Here is my question. 3750 to a 3750GThe switch is in a stack, what are the steps in upgrading this in the stack?I didnt set up the stack so i am not sure the steps. HELP!Thank you!Dustin
Hi all, when configuring access lists, what is the definition of an extended access list, I thought on a router it means source and dest, but when I configure an access list on my asa firewall, does it have a different meaning ?
Resolved! Rate Limit for guest internet access
HiI would like to limit the internet access bandwith for guest users on a Catalyst 3750 Stack (see attachment for layout) in the core.I saw that this is possible with the srr-queue limit command, but as I understand, this is relative value to the lin...
HiI've got nat translation configured on my router, but it doesn't seem to be working. If I run "show ip nat statistics" I can see that their are "0" active dynamic translations.Here's my config:Vlan100ip nat outsideVlan200ip nat insideip nat pool na...
Can someone please help me understand what a choke router is?thanks..
Resolved! Layer 2 - Access Lists
Hi everyone.I'm trying to find out how I can configure a "MAC Access-list" to allow only HP Devices through a switch port.I have never used this feature before and cannot seem to find any examples of how to do it ..Can anyone help ?
Resolved! 3750-E with 10g Module
Hi,Can I use 10g X2 module with 3750-E without TwinGiga Converter. Please clarify.Thanks,Senthil Kumar V
Hi I have a 4506 with minimal config, no routing enabled, purely layer 2 running 12 2 25 EWA14...On the sh platform cpu packet statI see Esmp highest avg packets per secondAny ideas of where to start looking...Sup 4.IOS
i have a router running the following ios:c3660-i-mz.122-5a.bin.I purchased this ios in order to do vpn:Cisco 3660 Ser IOS ENT/FW/IDS PLUS.Will it be compatible with the 3660 and could it do vpn?
Hi all, I have configured many access lists, however, I see that you can use the "ip access-list" and access-list command, what is the difference between these, I almost always use the ip access list one, whats the other for?
Hi all, is it possible for my router to block icmp requests to it ?
Dear All,I need config support for establishing a tunnelRouterA--PE--My Cloud--Internet Cloud--RouterBI want to create tunnel between RouterA and RouterB. Ultimately it is tunnel between two router connected via InternetHope you understand my require...
