Switching

I need a support document that explain the impact in performance when I cascade several switches does any ou you have any link?regards

I'm trying to implement HSRP for redundancy between two Gateway Routers. The problem is currently there is no dynamic routing setup for testing purposes. So there are only static routes in the gateway. That causes a problem for me if I give a new vir...

Hi there,I will very much appreciate suggestinos on the following problem.We are stting up a new network with HA and redundancy.We are using 2 2811 routers connected to 2 catalyst (one 4006 and another 4507).2811's are acting as DHCP servers, and for...

Dear sir, iam having 2 broadband serviceses from different isps so iam planing to do the loadbalance and automatic failover so plz suggest me if router require or any switch(managble switch require). plz give me the best possible. Thanks&Regards srin...

Hi All,We have a catalyst switch 2960, this switch will be connected to another switch from one side and to hosts from another side.Is there a way to configure the switch in case the link between the two switches is down bring all the ports connected...

Has anyone had an issue with sporatic ports working and not working on code s72033-ipservicesk9-vz.122-33.SXH2a.bin? What is the most stable ip services code currently for the 6513 sup720? We tested the cables and they are good.

What could be the cause of this problem:EVENT ID = 0000A18ALERT ID = 000014ITIME = Tue 05-Aug-2008 05:26:34 MSDSTATUS = ActiveSEVERITY = CriticalMANAGED OBJECT ...

Hi there,I have a port on a Cat 6509 in mode trunk :Interface Gigabit1/1 switchport switchport mode trunk switchport trunk allowed vlan 10,20!Is it possible for me to rewrte theese tags (10,20) to 11 and 21, so that I can have vlan interface for each...

Here's a good one. I have a blade system using (2) 3020 blade switches, (2) 3750's in a stack at the core. 4-port LACP etherchannel/port-channel (Po8) between ea. 3020 and 3750 stack, with (2) ports in the master, (2) ports in the slave. LACP active ...

Hi all,Does Catos show how it was rebooted like power on , reload .. etc.Can i know the CATOS command.

Is there training for the Cisco Catalyst 6500 Virtual Switching System 1440?

Hi All,A very basic question.I know ospf dont generate a defualt route unless we specify the deault information originate command. I would like to know the reason behind such behaviour. Though I have a default route and redistribute static routes to ...

Dear all,we had given 120mb link to customer. A end we have GSR and at B end we had 7200 router--Both end Gig port. When we kept MTU=1700 at both end or default 1500 . customer was able to open indian web pagesWhen we changed MTU on transmission equi...

I need help on setting up routing for a single subnet.At the moment all traffic is routed via the etherchannel(po1) to the R2 Router via ospf. What i would like to do is route a single SVI on the 4506 to R1 instead of R2.Can i apply a route map on th...