Switching

Hi,I have some questions about HSRP1# what is HSRP2# what is the use of HSRP?3# why do we need it4# Explain it with examplesany help is appreciatedBava

I'm having trouble accessing the Internet after using SDM to setup my 851W. At this point, I'm just trying to get the wired LAN working.- DHCP on router 192.168.1.101-111- WAN (FE04) gets DHCP address from cable modem- Firewall enabled- Local PC does...

What is stuck in active in EIGRP?can anyone explain it with examples.RegardsBava

I have 5 core 6513 catalyst switch, each of those are configured VTP server for the same domain. As far as I know VTP server advertise vtp packet with configuration revision number? Clients look at the vlan that VTP server advertise and configured th...

I am trying to set up dhcp snooping and was just wondering if the commands below are what I should be using for COS and IOS. Also, how would I do a test to see if the switch disables the port if it detects a DHCP server? I was thinking I could use IC...

what is the maximum upgradable limit available for C3560 memory?

Hello,During an IOS upgrade (non K9 to K9 version) on a stack, if the stack master is upgraded, I understand it will push that IOS upgrade automatically to the other stack members via the "auto-upgrade" option. This is enabled by default. If the stac...

I have a few 3750 in a stack...how do I view the utilization on those stack ports? I'm thinking about replacing them with 3560G switches with a few trunk ports in an etherchannel but I want to see what the utilization is on the stack to see if that'...

Hello, I'm tryng to enable BFD for OSPF on a SVI on a Catalyst 6509 Sup 720.Even if the vlan interface accepts the configuration command "ip ospf bfd", no BFD neighborship is established and there is no way to set bfd intervals.Has anybody encounter...

Hello,I am having problem routing from the old network (10.223.17.0)to the new network (10.223.12.0). I want these 2 network to communicate with each other.Below is the current config of our core switch(4507R). Any changes or ideas is greatly appreci...

I am trying to configure my network to do remote installation here is the configuration belowAll the servers are in VLan 9 All the other vlans are configured with these commandInt vlan 2Ip address 192.168.79.1 255.255.255.0Ip helper-address 192.168.7...

I have 2 cisco shops(Hosp) that are tied together with a VPN that they setup. on the LAN the radio equipment works fine but I cannot get it accross the WAN. I have other equipment same MODEL and firm ware the works on the WAN. WE use UDP/IP in a uni...

On 6500 at switched port I have enabled 'mls qos trust dscp'. I want to monitor DSCP trusted packets counter on 6500 (like we get details on 3550 using 'mls qos monitor dscp <>' and 'show mls qos interface statistics <>'commands)?