Switching

I have tried to get our 6500 to use the PDC emulator for our domain as an NTP server by specifying "ntp server x.x.x.x" where the IP address is that of the said server.Although the switch states that this is the configured NTP server it isn't synchro...

Is this just how an ethernet network switch works ? whereas a hub is not this ?carl

Can anyone list the plain differences between these in simple terms ?cheersCarl

Hi, by default PAGP is enabled in all the modules of 6509 where etherchannel also running on PAGP, now if i enable LACP on a particular module, where there are no etherchannels running, just enabling the LACP for module 9, will cause any problem to t...

I have this error when I start my router System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1) Copyright (c) 2003 by cisco Systems, Inc. Bad RAM at location 0x00000000: wrote 0x00000000, read 0x00000400 Which is the problem? How can I...

Hi.How can i do to configure port priority in the Catalyst 500 express?

Hi,I have a Cisco 2960 switch connected from port f0/48 to port F5/48 on a Cisco 6500 via a cross-over cable. The link is configured as a trunk (mode=on). Both interfaces are set to 100mb and Full-Duplex. The average amount of traffic traversing th...

Hi,How can we kill specified number of CPU process when we seem them running in the router..cheers,saurabh

I have a LAN/WAN connection using Cisco and MRV equipment. Our ISP uses MRV on the WAN side and we have Cisco across the board on the LAN side. For example:Cisco(LAN)--MRV--(WAN)--MRV--Cisco(LAN)Our Cisco equipment consists of a core 6500 and the r...

Hi All,I have a ce500 tt that is rebooting quite often. It is on a ups. One thing that is common is that the time and date are wrong when the restart occures. I cannot save an ntp server even though I enter one and save it.Any thoughtsthanks

is it possible to configure two router interfaces of the same subnet?

Is RMON for routers only, or can you boot and "break" into ROMMON on a switch also?

We use Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9K91S-M), Version 12.2(25)EWA2, RELEASE SOFTWARE (fc2), will this series support auxiliary vlan command, i need it to configure voice vlan in auxiliary port.regardsBabu

Hi,I have this configuration on two routers:Router 1interface FastEthernet0/0.1 encapsulation dot1Q 1 native ip address 10.1.120.254 255.255.255.0 secondary ip address 10.1.6.163 255.255.248.0 ip helper-address 10.4.0.51 ip helper-address 10.4.0.52 ...