Hello, We are using a point-2-point connection, 2611 and 1760. Connection speed has been unbelievable slow, ran a "show int" and noticed quiet of few drops. I am a newbie and would like someone to point me in the right direction on where to star...
In one of my location using catalyst2900 eriesXl switch with IOS ver 11.2.I want to make one port as span for the other port where i connect my firewall for the process of monitering the triffic.Can I do the span port on this switch if so what is th...
I havent had to setup any repeaters in the wireless networks I have designed..In this specific case, I am thinking about using a repeater to establish a wireless shot between four locations. Here is the scenario.. Site1---Site 2(Omni)----Site 3(Repea...
I'm trying to do a traceroute mac ip to see the layer 2 hops thru the network.. both switches are identical configuration other than management vlan ip address. 2950 Enhanced running 12.1.22(ea1)management vlan is vlan 130.. yet I'm getting this resp...
the main aim is to replace our c-5500. I know it's very general atm but more details will come lately. i just want ur opinion on which router can be used instead of 5500 for a network evolution.currently here the network schema : -> c-5500 <--> c-550...
I don't know much about servers and knows a little about cisco. We have a server in the campus data center and we have some users in a building in the same campus having slowness problems connectingto the server in the afternoons. We have other user...
Dear all,just thought I'd share with you a peculiar effect we have noticed at our Academy, where lots of people are often erasing and saving configs.We are using 2620 routers with 12.2(7a) IOS. The issue is as follows:Sometimes students mis-spell the...
I have a strange problem with all catalysts (2948g's, 5500's) on our network. We just moved to an ACS for RADIUS authentication to these switches so I used Ciscoworks to push out the config changes to the switches (all it did was to change the IP add...
I need help configuring my router, I have 2 internet connections:FIRST ONE:63.245.89.81255.255.255.248SECOND:65.165.87.177255.255.255.240I have a Cisco 3725 with 4 Fastethernet ports, also I have the “C” class 69.79.30.0, that one is attached to the ...
I am designing a WAN for a small company. I am familiar with networking and basic cisco router configuration, however I have never attempted anything of this scope. My situation is as follows:The company currently has one main office and two branch o...
HI,I have a very basic question, would appreciate if you can give me a prompt answer.I have one ISP connnected on one serial interface.He is confirming that he has given me 2 Mbps one to one Bandwidth.How can i check it from the IOS commands that he ...
OK, I have a 2524 with 2 t1 wics along with two circuits. We have an announcement list that we run like 3 times a week that allowed me to notice that mail was not going out as fast as it ususally does. We are talking about a fraction...like 5% of t...
Can't log in via console port on the router.In config:line con 0 transport input noneI can remove this but if I reboot it's back there.Solved it once but can't remember how I did it.Thanks,Peter
