Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I learned that MED is applied to outbound updates , dictating the best inbound traffic into the AS, but I saw the vice-versa is also true like you can apply med for indbound updates also and it works the same right??
Post 3.4, patch 4, Replication stop between PAN and PSNs, error, Jediss replication failed, CLI access issue-error failed to connect to the server. throwing an error in the debug log : Error, Failed to connect to server, could not connect to test-ise...
Exploring the feasibility of live audio streaming within Cisco CVP, this post outlines an approach using a custom VXML application connected to a transcoding proxy. The proxy converts MP3/AAC streams into G.711 or 8kHz WAV for VVB playback, while DTM...
Hi All,We're facing issues in C9300-48UXM 8-Stack switches running IOS-XE 17.9.1. All our Vicon IP cameras are goes offline when the switches are suddenly rebooted due to maintenance. POE devices are online like Cisco IP phone, Cisco APs, PC, and oth...
I have a Cisco switch that is not connecting to the network after a recent configuration change. All cables and ports seem fine. Has anyone experienced this issue and found a solution?
Hello FreindsMy MGMT WS-3750-X is running on just one power supply. How do I disable the below behavior and force the switch only to accept 1 PSU Line power Jan 2 00:57:58.436: %PLATFORM_STACKPOWER-4-REDUNDANCY_LOSS: Switch 1's power stack lost redun...
cp8851 asking for acitvation codeit was working for during router / electrical outage it recycled and now asking for codethis is new phone and no code in box.
Hello FreindsI Have 4 x F5 BIG-IP i5800 Hardware, need to provision 2 per Site in Active/Standby mode, ACI Multi-site ArchitectureI Have the following questions4 x F5 BIG-IP i5800 Hardware1. What is the Recomendation for the Failover Link, Back to Ba...
I do not see hostname field for some of the endpoints. these endpoint IP's are assigned statically no there is no DHCP involved. probe wise I have radius and nmap enabled. Do I require DNS Probe to enabled ? what is the requirement from ISE perspec...
お世話になっております。無線APがLocalモードの場合、ネットワークスイッチのshow mac address-tableの実行結果に無線クライアントのMACアドレスは出力されない認識なのですが、FlexConnectの場合は無線クライアントのMACアドレスが出力され、flappingを示すログが出力されていました。以下についてご存じの方いらっしゃいますか。①FlexConnectモードの場合は、無線APを接続しているネットワークスイッチのshow mac address-tableに無線クラ...
We have a 9800 controller running the version Cupertino 17.9.4a and the Rommon version 16.10(2r). We want to upgrade it to version 17.12.3. My question is whether it's necessary to update the Rommon to avoid issues during this upgrade?
Some students have accommodations requiring 1.5x or 2x time on exams. I've been unable to find how to set up NetAcad CCNA Module Exams or Finals to allow these for individual students. Is there a way to do that?Sorry if this is the wrong forum but I ...
i have had the system i have in place for some time and had no problems, when using a 2 router approach [isp1 and isp2] but since i merged both onto 1 device, ISRC111 there is an issue with incoming connections via isp1. i am using the same acl's and...
