Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I don't understand the working of DMVPN especially in phase 2 and phase 3. When talking about NHRP Resolution request from one spoke to another spoke through the hub, like why do even need that request to go to all the way through hub. Isn't it good ...
A new Generally Available MG Wireless WAN firmware version is available. Firmware MG 26.1.3 was released on 2026-05-14 and has been in this firmware category since 2026-05-14 UTC.
Hi Community, I have a strange issue. When I use SSH Terminal Tools on vManage GUI to access the cEdge device. SSH Terminal does not connect to the SSH session but redirect to the dashboard login vManage.This happens when I upgrade the Controller to ...
Do you know how to get C9300 XXX voltage input for each PS using SMNP? If I go by ssh all environments are listed. I was trying MIB walker but still not showing the correct OIDs. show env allSensor List — Environmental MonitoringLocation State Readi...
We are running into this bug on several of our 5108 chassis with the 2408 IOMs. Our fabric interconnects are 6400 series with intersight firmware bundle 4.3(6.250084), which is the recommended version. We are fixing the problem by having Cisco clea...
Hi Having an issue with the 9800 controller setup in sso, where I cant get clients to get a dhcp reply. The aps are up.. the ssid are up.. but external dhcp not so much I have tried setting it up globally under policy without effect. I have tried se...
With 802.1x and MAB failover rolled out, instead of allowing entire OUI's for printers and things like that we are looking at utilising stricter device lists.Our helpdesk and local site technicians don't have access to ISE, so to reduce the load on u...
Hi,We are using Cisco 3500 Series Wireless Controller and around 10 units of C9115AXI-K wireless access points. Everything was working fine until last 2 weeks where users started complaining the internet is breaking, Teams call are getting disconnect...
Hi!I would like to ask if someone else is having or experienced this kind of issue. I have several C9105-AXI-EWC access points and they stopped working all of the sudden at the same time. Light indicator is steady green instead of the usual steady bl...
Hi AllI need help with Meraki MV devices not working to aws for cloud backup, we have created a test rule for TC 443 to ANY destination.As per Meraki they are seeing SSL inspection breaking the certificate chain, any help/advice would be great.
Hello all,I have a small network used for live events and broadcast production. Two Cisco CBS250 switches linked with a 75m copper trunk... VLANs for Control/Management, Dante audio, and sACN lighting. Some simple interVLAN routing and basic internet...
Hello Everyone,Looking for some guidance on SDA migration. We have around 10K users spread across several floors. Need to migrate the site to SD-Access. We intend to do this floor-by-floor cutover. Please note, majority of the users are on wireless a...
One of my clients asking these questions: 1. Which cause codes are categorized as abandoned calls?2. Which cause codes represent human error? Many of the failures on my network are due to users misdialing; for example, some dial only eight digits in...
How long does it take for an unregistered IP phone's status to change to 'None'? Based on my research, it should only take 72 hours; however, I noticed that some IP phones still show a status of 'Unregistered' even though they were disconnected 10 da...
Hello ISE Community, I am wondering if anyone else is seeing this same alarm for "ERS request content-type header is out-dated" even though the current ISE supported RESTFul API is being used per Cisco documentation. I am currently running ISE 3.3 Pa...
