Activity in Technology and Support
CUC Configuration
I have multiple voicemail users. What configuration do I need to set up in the CUC Direct Routing Rules or Forwarded Routing Rules to ensure that calls are routed to the correct voicemail user? I’ve already created the voicemail pilot and profile in ...
9200CX USB Console Not Recognized After Switch Already Booted
9200CX USB Console — Not Recognized When Connected After Switch Has Already Booted (works fine if connected before power-on)Posting this in case it's helpful to others, or in case someone from Cisco/TAC can confirm whether this is expected behavior.P...
RIP (Routing Information Protocol)
Routing Information Protocol (RIP) is one of the oldest and most straightforward interior gateway protocols (IGP) used in computer networking. Initially developed in the 1980s, RIP has undergone several revisions, with the most widely used version be...
Cisco AI-RRM || AI RF Profile best practices
Hi Team,We have deployed AI RRM over Catalyst centre and Meraki.However some of the sites are facing wifi issues which were stable when AI RRM was not implemented.we had channel width set to Manual - 40 everywhere, however AI RRM is leading to issues...
Resolved! Installing Linux VMs Gives Black Screen
ENCS5412/K9 NFVIS-4.10.1-FC3 I have tried the following four Linux ISOs: ubuntu-22.04.2-live-server-amd64.isoRocky-9.1-x86_64-minimal.isoRocky-8.7-x86_64-minimal.isoRocky-8.3-x86_64-minimal.iso On all four ISOs, the VMs boot, I select the option to i...
Change customize Cross-Origin-Resource-Policy
In the CMS service, is it possible to set the Cross-Origin-Resource-Policy header to “same-origin” or “same-site”?
Cisco Switches redundancy between Core and Access switches
Hi,Has anyone tried to design network , hardware , software redundancy between 2 Core Switches and 3 access switches in standalone in separate network rack with no possibility of stacking.
IOS-XR - Changing the VRF on interface without removing the IP address
Hello, everyone.I am reading the MPLS Layer 3 VPN Configuration guide for ASR 9000 which states:https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/26xx/l3vpn/configuration/guide/b-l3vpn-cg-asr9000-26xx.pdfYou must remove IPv4/IPv6 address...
GRE Tunnel Issue using VRF
##### Turns out it was KEEPALIVES ### This should be simple but I cannot get it to work!One end of the GRE Tunnel is C9500-24Y4C. Advantage licensing.Other end is a Palo Alto FW.I'm trying to stick the switch side tunnel interface into a specific VRF...
Resolved! 9167E configuration guide in unified platform
As far as I have understand the newer 17.18.2 software version on 9800 wlc It is possible to configure the 9167E as URWB. So I have the following questions:When i want to use on a single 9167E AP simultaneously as URWB and for WiFi for the clients do...
UCCE PIM preemption / priority between PGs
Hi,We have two UCCE PG sites configured as an Active/Standby pair.One of the sites is not very stable, so we want Site B to always be the preferred/active site. If the PIMs fail over to Site A due to an issue on Site B, we want them to automatically ...
Does anyone have CIPC 8.6.6.1 or 8.6.6.17 they can share?
We encountered a bug with a DLL file that was fixed in CIPC 8.6.6.1 but that version appears to have been scrubbed from the internet.We then noticed there's a 8.6.6.17 version but we're unable to download a copy.We've been using 8.6.6.0 for a long ti...
Resolved! Cisco Room Bar pRo with Shure mXA920 - aes67 setup
Dear Cisco Support Team,We are currently working on integrating AES67 audio from a Shure MXA920R microphone to a Cisco Room Bar Pro and are following the official integration guidelines.Here is a summary of our current setup:The AV Integrator licens...
Resolved! Catalyst 2960x IOS Rollback issue
I am attempting upgrade the ios on a few Catalyst c2960x-48FPD-L. There can be minimal to no downtime for these switches so before we push the upgrade, we are attempting it on a spare switch we have. I also want to test rolling back to the current sw...
I need to change the name in Pearson Vue in order to book an exam
I need to change the name in Pearson Vue in order to book an exam. I is different from my Netacad name.
| User | Helpful Count |
|---|---|
| 89 | |
| 58 | |
| 53 | |
| 45 | |
| 38 |
