hello people I have a Cisco ISE 2.7 and want to upgraded to 3.1 and then to the recommended release, but the thing is it's using its own CA for the authentication so doy you have any recommendations for this procedure? I wanted to do a full upgrade, ...
I am trying to configure the Presence Gateway for an integration with Office 365 and failing miserably at the Presence Gateway FQDN. All it says in the guide is that the Presence Gateway field should have either the fully qualified domain name or IP ...
Hi, We have a lot of laptop on which SecureClient is installed with Compliance Module We would like to upgrade the compliance module version, but we wonder if the download request to update this module can "kill" our ISE servers (2 PSN are used for...
Good afternoon,We are trying to create a button that helps us display a URL both on the touch screen and on the television. The script is as follows: const config = { button: { name: 'Web View', // The main button name on the UI and its Panel Pag...
Hi Team,In our environment we are using C9300 and WS-C3850 model but on 18 Oct 2025 my site network was unreachable for 15-18 minutes after that everything was normal.During the network unreachable, WAN (DIA and MPLS) were fine and all switches time ...
Hello Together,we installed a new FMC in Azure for some testings. Now I stuck because how can I add a physical FTD to this FMC in Azure Cloud? I tried it form Inside an office with the normal command "configure manager add ....", but it won´t work. T...
I used to be able to do a "show arp vrf all | inc x.x.x.x in the 9000 series routers. We recently switched over to 8500 series. It appears I can't do that command. Is there a work around?
Hello Cisco Community,I was hoping someone could help me figure out why my CW9178I's MIC is not being accepted by my 9800-L-F controller.All of my troubleshooting has lead me to believe that the AP cert if not being accepted due to being invalid/inac...
Hello Cisco Community,I was hoping someone could help me figure out why my CW9178I's MIC is not being accepted by my 9800-L-F controller.All of my troubleshooting has lead me to believe that the AP cert if not being accepted due to being invalid/inac...
Hello everyone I'm going to upgrade cisco ISE from ver 3.1.0.518 patch 10 to version 3.3, so I want you to ask could I downgrade back to 3.1p10 from 3.3 if smth goes wrong?
Hello,I’m preparing to deploy a Windows Server 2025 Hyper-V cluster on a Cisco UCS X9508 chassis, and I’d like to understand the best practices for this setup.In particular, I’d appreciate advice on the following points:Recommended firmware versions ...
Dear Community,I’m facing an issue with a single-TLOC Cisco SD-WAN branch (Catalyst 8200/8300 on IOS XE 17.15.03, vManage 20.15.03) where the WAN Edge fails to establish BFD Tunnels with other sites even though it can reach the Cisco-hosted Controlle...
Hello Community,I have configured my Cisco Firepower Management Center (FMC) using the UI. Now I want to retrieve these configurations using any of the following methods,CLIAPIFile ExportAlso, I want to verify whether my device setup is correct.Any g...
after an acquire other company i have in lab an ASR1002-HX with 16.9.7 fuji fw version. As i see the box have RTU licenses not smart. Question is for what bandwidth is this box useable with rtu licenses without aby smart licences? Does it support 100...
Hi, I still don´t fully understand the licensing in relation to Cisco ASA Firepower Licensing. I already asked a question regarding the FMC here: https://supportforums.cisco.com/discussion/13086371/firesight-license-60-not-needed. I learned, that fo...
