Activity in Technology and Support
Question on Cisco 8000V router
Hello,I have a question on Cisco 8000V router.Does the Cisco 8000v Advanced license include DMVPN functionality?Also, are there any limitations regarding site-to-site VPNs?Does it support firewalling features, such as NGFW capabilities?Additionally, ...
IKEv2 Remote Access VPN Failure to Connect
Good evening,I previously had an IKEv2 Remote Access VPN tunnel working properly on an ASA 5515-X but apparently made some changes that have broken this functionality, so I appreciate any assistance that can be offered in restoring functionality. I h...
10Gbps link between FPR3130 and C9300-NM-8X keeps bouncing
I have a 2 x 10Gbps port-channel using DAC cables (SFP-H10GB-CU3M) between a FPR3130 chassis ports Ethernet 9 & 10 and a C9300-24T with a C9300-NM-8X module ports Te1/1/1 & Te1/1/2. The switch is constantly reporting the interface going down for abo...
WSA Upgrade from 14.5.0-537 to 15.2.3-007 – What to check before
Hi Cisco Community, I'm planning to upgrade our **Cisco Web Security Appliance (WSA)** from **AsyncOS 14.5.0-537** to **15.2.3-007**. Should anyone tell me the best practices and what to check before the upgrade? Looking for advice on:1. Any **criti...
vpc back-to-back connect to same distributed switch
Hi,i have this question. I know that i can create a vpc back-to-back configuration between a pair of n3k and n5k. my question is, if i create on each couple of nexus e lacp portchannel to the same distribution switch stack will create a loop?thanksAn...
ASR9000 Line Card Labeling – A9K‑8X100G‑LB‑SE vs A9K‑8X100GE‑L‑SE
Hello everyone, I’m in the process of ordering some ASR 9000 8x100GE SE line cards and I need to confirm something before proceeding. The part number I am ordering is:A9K‑8X100G‑LB‑SE However, we've been advised the following: “These cards will alwa...
Resolved! Get-Content fails to recognize DUO installer as a valid executable
My PS7 script uses: $firstBytes = Get-Content $installerPath -Encoding ASCII -TotalCount 4 $magicHeader = $firstBytes -join ' 'if ($magicHeader -ne '77 90 144 0') {Write-Host "failed"; exit}I have also tried ASCII, UTF8 and Default for encodings, but...
Catalyst Center Changing Device IP in ISE away from Management IP
Hello Community,I've got Catalyst Center running version 2.3.7.7 monitoring our devices with Assurance, handling SWIM, doing traditional networking CLI templates and integrated with ISE 3.3 (not managing policies, just setup in Network Settings for N...
Service Graph PBR Consumed/Provided Issue
Hi,Im trying to configure a PBR betwen 2 EPGs but camed across with an issue.The PBR is working fine from consumed to provided.The issue is, it still works from provided to consumed. Even with "Reverse Filter Ports" disable.Is this behavior correct...
Cisco SDWAN - API Request no longer works with 20.15
Hello, This API Request no longer works with vManage Version 20.15 /dataservice/system/device/vedges?system-ip=10.255.255.86 This used to work prior to version 20.15, I have many of my scripts using it I can get device information using this request:...
Trying to overcome OpenVPN Reneg-Seconds
I've installed a Unifi Dream machine and used Duo as it's Radius, I use LDAP for primary auth and Duo Push as MFA. All is well...For an hour then OpenVPN forces it's hourly renegotiation and another push is sent out which must be approved. Not keen o...
Resolved! Redundant Extension Mobility Service
Hello Experts,I am trying to use (DNS) as a redundancy mechanism for our Extension Mobility service. I associated the name EMSRV01 with 2 subscribers IP addresses 10.108.231.10 and 10.107.231.11. I associated the name (EMSRV01) with the demain name (...
ASA5545 upgrade to FTD
Hi AllWe are looking at upgrading our ASA5545 to an FTD, what is the replacement model for this? I was thinking the 1150 model.When I look at the specs it says maximum vpn peers 800, does this mean anyconnect sessions and site to site ipsec etc?The 5...
Resolved! Can FMC running in vsphere be migrated to AWS?
I plan to migrate a FMC running in vsphere to AWS. Initially I plan to: 1. Build the FMC in AWS as brand new; 2. Backup the existing FMC (running v7 already) and then restore the backup in AWS FMC; 3. Login to AWS FMC serial console to change the MGM...
CSCvs68674 - DCNM Config Archive Job Doesn't Get Triggered
We're operating DCNM 11 cluster that manages a single Nexus switch. Since the Nexus 9K switch doesn't have any ability to backup configuration over a secure transport protocol (e.g. SCP), we aim to configure archive jobs on the DCNM so that switch co...
| User | Helpful Count |
|---|---|
| 99 | |
| 91 | |
| 90 | |
| 75 | |
| 63 |
