I am suresh, I am having the IPTV3441 BCAST server with the IPTV server version 3.5 and content manger 3.5. I like to know about viewer , is it necessary to me have iptv Viewer. How can my users view the broadcast. Do i have to install a software. ...
I've noticed that when creating CTI ports through IPCCX 4.0(3), leading zeros are ignored. For example, CTI ports 00001XXX are created as 1XXX. Is there a workaround?
I am running inboung faxing on a 2821XM router, 256MB, 12.3(11)T8 using the on-ramp/off-ramp TCL's 2.0.0.0 (outbound is configured, but not used), with 2xe1's (primarily used for voice). Incoming is working fine for the majority of messages (about 5 ...
Hi allI have a CCME ver4 in a router 2811 with 4 fxo ports to PSTN and 20 ip phones.I need establish password code by users to have different type the access to the PSTN (local, LD, LDI), and that the phone number and code password appear in the repo...
Hello,I have an existing TI Voice PRI module on a 1760 Router. This is my gateway to the public side. The PRI is supporting 100 block range of DIDs. I will be opening a new campus soon and will be needing to route another 100 block range of DIDs thro...
Hi,I got an alert saying that Number of rows in calldetailrecord table in CDR database has crossed the threshold limit. What does this mean and how do I resolve that?Thanks
As I can lower the time that is delayed in dialing when I have symbol T in destination pattern. dial-peer voice 1 pots trunkgroup fxos description anexos-locales destination-pattern 1..T no digit-strip! dial-peer voice 10 pots trunkgroup f...
Hi All, We have an IPCC(Ent) v6.0 with CCM 4.1 VoIP environment at the call center. The Agents use CTIOS softphone, and we have "Reason Codes" configured to track the Off-Phone activity of Agents. When the Agents have to switch the "Reason Code" from...
Hi there.We currently run a trial version of CiscoWorks Voice Manager 3.0It is going fine except by the lack of utilisation & statistics for analog and digital (ISDN/E1/T1) from the existing Cisco voice gateways.We heard that Cisco Unified Operation ...
I have a Polycom video system with a SE200 gatekeeper. Our 4.1(3) CCM has a H225 trunk that registers with the Polycom gatekeeper. I can place audio and video calls both ways across the trunk just fine between IP phones, Advantage VT, and the Polycom...
I've set up a fairly simple CCM system with a GK h225 trunk to a local GK. The GK has several local zones only. There are 2 netmeeting PCs registered via the GK. There are 2 VTA devices on CCM.I can make calls to/from all the devices without problem....
Hello all,I tried to restore factory default of IP/VC 3511, however IP/VC still have previous configuraiton.How can i restore factory default?---------- restore procedure -----------A log of the auto-boot events displays on the computer. Step 5 When ...
I am using a Genetec Omnicast server to stream video to the internet, through a DSL line. Since I put Cisco 831 routers between each end points, video sessions do freeze regularly (before I used linksys routers). I do not see any latency, queuing or ...
