TelePresence and Video Infrastructure

Does anyone have suggestion on VoIP monitoring and management tools for large enterprise voip infrastructure?We are in the final phase of 8000 phone cut-over across 2 location (2clusters) and need some advice on choosing the right monitoring system.I...

Hi,I have 2 H.323 gateways which I would like to use in a redundant fashion. I configured 3 dial peers on GW1: PRI first, then voip dial-peer to the 2nd GW, then POTS line for backup (config is in the attachment). However, it looks like the pots dial...

I am currently using Cisco VTA for point to point video conferencing call, with CallManager 4.0.2a. I am looking at some of Tandberg video conferencing endpoints for large conference room.Does any body know if you can do video conference call between...

hi i am ccna and iam new to voip enviroment so i want to have some basic knoledge of this differnce in order to build voice over ip network

Hi experts,I 'm installing 2 PGW 9.2.2 on 2 sunfire v120 (one disk on one sun). So I follow the guides on Cisco Install guide document.The procedure I do as:1 - Install Sun solaris 82 - Install Patch CSCOh0153 - Install MGC software 9.2.24 - Install ...

dear, I am new in VOIP and facing the following problems in VOIP: Voice breakage Echo Jitter Loss Distortion one-way-voice underwater voice robotic voice voice getting lower and heard less dont just tell me the cause of these problems, kindly tell me...

Hi all,Is there any tools/commands available for Cisco 2621XM (2600 series), with which we can measure the voice quality of VOIP and TDM calls. Is it possible to get some statistical information about the voice call.What are the metrics used by Cisco...

Hi All,We have CCM version 4.1 running here, with VTA 2.0 deployed. We have an H.323 trunk to a 2621 based gatekeeper and H.323 endpoints (Tandberg). I am able to call from my VTA to any of the H.323 systems with no problem, but calling to another ...

Did someone used Aethra (thesus) model video ip phone with Avaya PBX ?

Hi,I have an cisco router 3825 (IOS 12.3(11)T8) with a isdn E1 connected to PSTN and i want connect i have a VIC2-2BRI NT/TE to a video conference system of PictureTel.My configs in BRI are:interface BRI0/2/0 no ip address isdn switch-type basic-net3...

Anybody know when and if Video Advantage 2.0 (PC video) will support H264?I am setting up a Polycom MCU based system, and am considering these 2 PC options:1. Polycom PVX with Web Office, which does do H264, but does not have the IP phone integration...

I'm trying to figure out what I need to build a videoconferencing system. I already have: Main site with a Cisco 3825 w/ Adv IP 12.4, where I expect I'll have 5 - 10 users who will regularly use a videoconferencing system Remote site with a Cisco 281...

What is the undocumented command to initiate a test call from IOS on a H323 gateway?Thanks in advance.

Hello, I have a config I am putting together for a customer who is running both voice and video over their frame network. The frame network consists of three sites; MI, DC, TX, with MI being the hub. The frame network is a full mesh with every site...

Hi,We are testing IP Communicator 2.0.1.1and are finding that when launching the audio tuning wizard the language changes to french, whereas when you have just installed the product it was in english?Is this a known issue?