Hi,
Vcs expressway edge with two nic's
one in the dmz and the other in the voice vlan .
Is it a valid configuration ?
Second thing , What type of NAT required ?
Any examples
Thanks
So, it looks like on CMS version 2.3 there should be a way to make the scope of an Outbound Rule to be "callBridge" (through the API) and then you can set the callbridge field to the ID of the callbridge itself (or use CallBridgeGroup) but I don't se...
Dear All,
Can I control 3 cameras connected in SX80 codec?
As you can see on the attached video, the Camera 1 has the only arrows to control and the other cameras doesn't have.
Is there any options I need to enable in the system configuration to ...
Dear Team,
We are proposing MX 800 with Third camera to one of our customers.
Can anyone of you please assist how to do the connectivity for third camera.
How to control third camera through Cisco touch panel.
Regards,
Vikas Kumar
Hi,
we have Cisco SX20 running on TC 7.3.6 with PHD12X camera. Tried changing HDMI port on LED along with HDMI cable but in vain. with TRC5 remote control, our camera is working fine with UP/DOWN/LEFT /Right movement.
We are unable to get our Sel...
Hi, How can we configure the default extension when calling a SIP address ?
So far, when we use the shortname of a unit (for example 2221), the system automatically appends a wrong SIP extension {@xrce.xeroxlabs.com). We would like the system to add ...
Hello!I have been trying to help a customer implement some CPL rules to allow certain users from jabber.com accounts to call in and reject others. I'm using the Rules from Configuration Call Policy Add Call Policy rule, and the Call Policy mode is s...
Hi all,
very pleasure to debate first time on Telepresence topics. I'm quite new on telepresence architecture but basic knowledges are clear, i hope :).
Supposing a scenario like this:
- CallManager for Cisco SIP telepresence end-point registration, ...
Hi,
EX90 message ... " Lost connection with control device".
I did factory reset.
but again message "Lost connection with control device" and no access with browser.
please direct .
Dears,
I have CMS 2.1.9, I did everything right in the configuration, and my CMS is registered to the CUCM,
my only issue here that i already installed the licenses to the server but i still get the license error and the server won't process any cal...
Good Morning.
Looking for assistance in creating an XML Script to be utilized within the Cisco TMS for an SX20.
I am looking to broadcast a message for the duration of the meeting, and thinking I can do so with an 'xCommand'.
During testing I can...
We had brought Camera SX 20. During Unpackaging of the new product. We found out the Internal cable connector connecting SX20's Camera to Rotor Motor Base is broken. Is it possible to rectify the problem by either splicing the connecting tape ourselv...
