Dear All, i already install codec c60. when i try to share a presentation, i should use the remote and select presentation > pc.because the default is no presentation. can i change the presentation to pc as default? Thx,Anju
Hi allI have the follow situation:- Jabber for Windows 9.7 (allowed to make Video and Audio Call)- CUCM 9.1.2- Software Audio Conference Bridge available/configured- Codian MCU 4.4 registered on the CUCM as Video Conference bridgeProblem:If I make an...
Hello I am bk.I upgrade my sx20 to version 7.1, command : systemtools rootsettings on <password> show error....!how to setting root password... or how to make userid.... I need make tcpdump....
I have an MX300 which I'm trying to upgrade from 7.0.1 to 7.0.2 via TMS. I've upgraded one other MX300 and a number of MX200's using the same image withour any issues. When I try the upgrade via TMS I get the following error: The event failed to co...
Anybody have documentation or configuration guide that states FIPS should be disabled in Windows 2008? I've seen documentation that implies MXPs are not supported, but nothing definitive. Can anybody point to documentation validating the following ...
Hi All, We recently updated to TC7 and are taking a look at the new diagnostic tabs. I see 0% packet loss consistantly on the majority of the calls but I see a large variance in the Max Jitter numbers everywhere from 4 to 63. I was wondering what do...
Hello, I have CUCM - > VCS - > VCS Express deployment. Some endpoints are registered to CUCM and others are registered to VCS.I have prepared the prerequisites, so please correct me if I am wrong.VCS:Private IP Address, subnet mask, and gateway.Loca...
How to configure FXO/FXS port on 3800 series router for analog fax machine use? I am using VIC2 -4fxo & VIC3-4fxs.How would I configure the ports to support this and also the dial peer? Thanks for any help/examples. Regards,Ajay Jose K
I fornd a tread that talked to integrating an older Call Manager 4.x with an older Polycom RMX.I am looking for some guidance in answering if I can use an RMX2000 as a Video/audio MCU for doing video conferencing between a bunch of cisco phones with ...
I upgraded from X.7.1.1 to X.8.1.1. I no longer get video or audio across traversal. everything works internal. Video/Audio also works if registered to the expressway calling outside of network. It is only traversal link. I have asked them to con...
Hi,I have upgraded all EX-Series at the customer to TC7.1.1.Now, by chance, I've noticed that some of them didn't upgrade the Touch, sitll running on TC7.0.2. Anyone an idea?kind regards,
Dear Team, i have a question of sx20. i have done downgrade the version of sx20 from TC6.2.0 to TC6.0.0 without trelease key but now we are facing the issue that display of sx20 is showing missing the release key. so can i standup sx20 on previous v...
Hello everybody, I have questions regarding Cisco TelePresence C: I know that you can call to landlines and mobiles as well from these.I would like to know little bit more technical details about this:- what else should be part of installation TP C s...
Hello,my customer needs a solution to readout the serial number from all his Intouch devices. The codecs with the Intouch runs with several SW releases from 5.x to 7.x. and they are installed in many Europe countries.I hope that you have any idea or ...
