Hello, I am attempting to install Windows 2016 on B200M3's. On two of the blades I was able to do this successfully after setting the UCS Boot Policy from legacy to Uefi. After I did this I was able to install the OS, however after the OS was loa...
Forum Posts
Hi, Has anyone created a SNMP GET rule in their favorite monitoring system for Cisco UCS Manager to look for Faults? Specifically Critical and Major fault events? Regards, Orjan
With Cisco WAAS Appliances (WAE/WAVE) when the TCP connection limit of the device is reached, all new connections will be passed-thru without being optimized. What is the behaviour with ISR-WAAS and vWAAS(on UCS-modules) when the TCP connection lim...
Hello All, Can anyone help me out with ESXi boot from SAN. Currently we have all the ESXi servers boot from local disk and we want it to boot from SAN. we are using 3PAR SAN and need some help/instructions for creating boot policy in order to set up ...
I'm trying to install Linux on a new C220 M5 with the Cisco/Avago 12G HW Raid controller. I'm trying with just a single drive in Raid-0 config with a virtual drive configured and set as the boot drive. When I boot into the install Linux identifies...
Resolved! Unable to boot UCS blade from SAN
I have cloned an existing profile and attached to a B200M3 blade in UCS 5108 chassis. The initiators seems to register fine on SAN. However, unable to see boot LUN's configured. * There are no local drives * First boot order is SAN and Second is cd-r...
I have forgot to bind to a HBA Template while did the customer activation. Can we bind a vHBA Template while blade is in production ? Does this cause a Host Reboot or any issue for SAN traffic to customer ?
I am trying to set up the replication network at our DR site using an existing vlan. I get this message. Post Replication Network Configuration validation failed. There are some unreachable servers from list: 172.20.16.154, 172.20.16.150, 172.20.16...
hi, We are building a new Data center and want to automate the deployment from the hardware layer up to the hypervisor. So the hypervisor is simple auto deploy, host template and boot tp. The part I am not sure is how to trigger the Blade association...
This session provides an opportunity to learn and ask questions about Cisco Nexus 3000 Series Switches hardware architecture and their role in Data Center / Enterprise switching design, configuration and troubleshooting.Cisco Nexus 3000 Series Switc...
We added Intel P4510/2TB Drives on three C220M5 as a second drive. (The first ones are P4500 2TB) Performance is very good, but the fans spun up to maximum speed and stayed there. Power Policy "balanced" is applied with "success", but without any cha...
my fabric interconnect suddenly stopped working, its front panel is not showing any color and I am not able to get the console access too. Hope someone will help with this .
Resolved! UCS-5801 FI 6248UP upgrade failure
Hello all,I have done an upgrade of the UCS system. I moved from 2.0 to the lastest new one. While performing the upgrade everything seemed ok, but after the whole process was finished, both FI 6248UP will not come up. LEDs seems to be ok, but neithe...
Resolved! Recover FI
We took a extended power failure, and one of our FI's didn't come back. We reset the power on it, hoping it would come back, but it didn't. Connecting a console on it, and booting it again has exposed the problem as a corrupt image. The question I h...
Hello, I have some new B200 M5 blades to which I will be moving some ESXi servers. The old blades are B200 M4. Both the M4 and the M5 use the VIC 1340 LOMs. Both blades will be booting from SAN. I intend to migrate existing service profiles f...
