Unified Computing System Discussions

I got 2 6248up FI going to 2 N7k. can i stup enhanced vpc using both FI as active uplinks or can only 1 be active at one time?in ucsm, I am only seeing 1 pot channel on fabric A - with 4 uplinks 17-20but on fabric B i see 1 port channel with no links

Can B-series sever ping each other within the UCS chassis without ethernet uplink? Please advice.Thanks

when the server is distributed three long beeps, then the screen lights up "Configuring and testing memory, please wait ..." for an hour. Memory installed in the blue slots 6 to 4GB. 1 on the 146Gb hard drives and 2 300GB Early grateful

I have a C210 M2 server that is failing with an apparent (?) hardware issue. From the UCS cli, I see the following:# show fsm statusID: 11Server: sys/rack-unit-11    FSM 1:        Remote Result: Service Unavailable        Remote Error Code: 4106     ...

HiI just received a new UCS C200 M2 with a seperate LSI 9260-4i MegaRAID SAS HBA card. I have installed the card and connected the SAS cables and LSI battery-backup unit (BBU).When I turn on the server, it recognizes the card, but appear a message of...

Hi Guys,AFAIK, FI 6120XP has two MGMT interfaces:MGMT0: used for out-of-band management;MGMT1: for future use. Could you please confirm if this information is correct?I'm asking this because today I have two FI 6120 in a cluster configuration with bo...

Hello Experts ,Would anybody help if there is a way to disaable a CPU on a UCS C220 server ?Is there a jumper that is used for this purpose ?!!ASAPThanks guys

HI Team ,VCE team suggested us to upgrade the following inorder to support it.Kindly suggest how to achive this.I am new to UCS & dont have enough knowlegde about it.Pls help Cisco C200 M1/M2 firmware upgrade from 1.1(1d) to 1.4 (3c)2Cisco UCS firmwa...

          I am trying to connect UCS (B200 M2, FI 6120XP, M81KR) to iSCSI IBM DS3512 (dual storage controllers) using appliance ports. It should be 1 GB link, MTU 9000, no boot from iSCSI.  Cannot make it working ,   cannot ping from esxi5 blade to t...

Hi,I have the following scenario, Cisco UCS chassis with 2 Blade B440 placed in slot 5 and 7.The blade in slot 5 is taking some time but the VIFs get pinned (FI Uplink) after approx 3 min.as for the server in slot 7 the VIFs using the adapter 2 remai...