Voice Systems and Accessories - Small Business

Hi, pls let me introduce myself, my name is Nafi, and this is my first time try to deploy BE6000 systems.i wanna ask about license, where i can get my application license? like cucm, cpc, vcs and etc.then i wanna ask about step by step for configurin...

HiI am looking to find out which Cisco Voice  / Call control system the SPA302 would be compatible with. I found several discussions where it  is stated not to be compatible with UC5 and 3XX systems. But could not locate any actual compatibility info...

Ok, so I programmmed a button on everyone's phone as a page all at their request.In case it's important, the only way I saw to program the button was to put the page all number, 101, in the speed dial. Then it shows up on the first unused button on o...

My customer is trying to get a SPA8000 ATA (version 6.1.11) to do a SIP trunk conneciton to an AudioCodes SBC. We have the SIP trunk up and working, with lines 1-4 included in the trunk. Outbound calls from all lines in the trunk group work, and ever...

Salve,ho configurato uno SPA3102 e riesco ad inoltrare le chiamate ad un centralino (freeswitch).Se ad attaccare è l'utente dal lato analogico attacca correttamente, se invece ad attaccare è il centralino voip il chiamante (che ha chiamato sulla line...

Hi there,I get this error when trying to VPN into the UC540 remotely using this phone.  When using a browser to access the unit via the WAN address:  https://<wan ip>, i can log in and get access to internal resources.Steps taken:1) setup SSLVPN (Web...

If an administrative assistant has a button setup as a Phone Monitor for her Boss' extensionWhen he gets a call, Is there a way to have the LED/Button flash as well as have the phone ring?It looks like it will just flash Thanks,

Hi Community.Our customer doenst like to press first the "0" prefix for outgoing calls. How do i disable that, in CCA there isn't a option to disable that.But i know its possible trough CLI.Thanks and kind regards patrick

Hi all,How can i setup the extension for incoming call of a SPA500S Expansion Module, please advise. thanks.Joe

Hardware Info:Cisco SPA512GCisco SidecarFirmware: 7.5.5Cisco 2960 24port switch.Symptom:The sidecar is showing a BLF as in use (red) even though the user assigned to that extention is not on the phone. We are able to duplicate this in a lab enviornme...

Morning all,I just recently deployed a UC520 for a customer and they have a request. Since they are limited in physical phones they want to assign other end user extensions to two phones that already have a primary line assigned to them but they want...

Hello, Problem:  Cisco SPA112 ATA stopped providing phone / voice service.  It had been configured and working properly for at least approximately 3 months over DSL.  The "System" light slowly flashes green and most of the time I cannot log into the ...

Hello,I'm trying to configure IM and Presence on a BE6000 (version 9.1). I have followed all the steps shown on the video http://www.youtube.com/watch?v=zsnen0QT1c8 . After loging in on the IM an Presence for the first time, I supply the AXL credenti...

this is the 1st time to activaite license for BE6000please i need your help step by step in activaiting license for BE6000(with 3 servers configured CUCM, CUC & SUP).thanks