Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hello All, I'm wanting to do a Mobile IP demo for university and I have the following simple demo in mind - I would have 2 routers connected via a serial cable, with a LAN on each side. I'd have a Wireless Access Point on each LAN and set them so the...

RJSmith92 by • Visitor
  • 696 Views
  • 0 replies
  • 0 Helpful votes

Hi AllI am currently working on a WLAN migration from lightweight to autonomous and would like advice on whether the following scenario is possible.We've deployed an 8500HA pair at the customer's central HQ with the plan that SSIDs at the central HQ ...

R M C by • Level 3
  • 5390 Views
  • 4 replies
  • 0 Helpful votes

Hello I have 2 WLC in my company, 1 is backup of the other one.When i first connect the AP to the network, it is getting attached to the backup one, how can i cange it?However, the AP is connected in the same network of my production WLC, also,  when...

I have a new from the box 5508 which I am attempting to follow the initial setup process to IP it. When I make it through the initial setup the box reboots buts brings me back to the "terminate auto-install" prompt again for some weird reason?Any ide...

Greetings,I have a strange scenario I have been brought into at work. A loading dock that has 3 Cisco 1242ag units started filling the spectrum with noise keeping their set channel at 100% duty cycle. I'm using Cisco Spectrum Expert to locate the dev...

Allthought AIR-LAP1252AG-T-K9 has gigabit 0 configured to  "speed auto" it joins 6509 giga port as Full-duplex, 10Mb/s. AIR-LAP1252AG-T-K9 configutaion: #sh run int gigabitEthernet 0interface GigabitEthernet0 ip address dhcp client-id GigabitEthernet...

Resolved! 5760 IOS

 Hi Experts, I have 5760 with code 3.2.3SE and this does not support HA AP SSO.  The code that will support HA AP SSO is 3.3.x.  There is a latest code 3.6.0E available.  For the 3.3 train, the latest is 3.3.4SE.  Which code should I upgrade to?  Reg...

mcaoile by • Level 4
  • 894 Views
  • 2 replies
  • 0 Helpful votes

Hi, we're using a virtual Wireless LAN Controller (WLC) v7.5.102.0 and virtual Identity Service Engine (ISE) v1.2.0.899.All APs run in flexconnect mode, sometimes it happends that wireless clients are unable to associate with the AP (usually when it'...

jheuke007 by • Community Member
  • 4016 Views
  • 3 replies
  • 0 Helpful votes

Hi I am looking to mesh two 1242 or 2602 access points together.  I am in a mine environment which completely decimates 5ghz signals.  Therefore I need to connect the two APs using 2.4ghz.  Is my only option to buy 1522 APs?  I am currently getting a...

Review Cisco Networking for a $25 gift card