Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Hello -I am scratching my head on this one. We have an ultrasound machine that uses two probes in the 5Mhz & 8 Mhz frequency ranges.Recently I received a complaint that our APs are interferring with the device.Upon investigation we determined that ...
Resolved! Maximum No. of SSIDs
Hi all,I have a quick question that hopefully someone can answer.We have a Cisco 4402 Wireless LAN Controller (S/W Version - 7.0.116.0) centrally managing 36 Cisco Wireless Access Points (combination of AIR-LAP1231G-E-K9 and AIR-LAP1242AG-E-K9).How m...
Resolved! Reboot AccessPoints over WLC4404
HI,We have two Cisco Wireless Controller 4404 with the IOS Version 7.0.220.0 and a lot of accesspoints (ca. 170). Now i wan't to reboot a group of Accesspoints where i found over a filter... Is this possible?Or how can i reboot all the AccessPoints a...
Resolved! Cisco MSE in the NCS
Hello,I have an MSE configured in de NCS. The MSE is reachable from the NCS. When I go in the NCS to the tab Home -> Context Aware, I don't see anything. When I restart the MSE I will see some data in the screen. But no new data is apearing in the sc...
Hi,I have one issue setting Wireless Access password on Aironet AP 1142.Password default length needed to set up is so long like " FEFEFEFEFEFEFEFEFEFEFEFEFE".Altogether 26 chacters.How can I make is customizable to be shorter.Thanks in advance.
I have 2 wrvs4400n routers. One is in sub level next to the cable modem feeding a gigabit switch for wired ports. Needless to say the wireless signal drops off on the other levels. Is there a way to utilize the other wrvs4400n to maximize wireless co...
Resolved! 802.1x - SSIDs and RADIUS Servers
Hello,I'm using PEAP and i need to know about a situation.I have two SSIDs (VIP and Collaborators) and both have 802.1x authentication in the same RADIUS Server but both have differences in web access.One have content filtering and another not.When i...
Hi, I am currently switching out our Cisco 1130 APs and Cisco Small Bussiness APs for Cisco 1142Ns (I will NOT be using a WLC), I have setup the AP, and read about some issues with Multicast and Apple Bon. Services. I ran the "no ip igmp snooping" co...
Resolved! Keep one AP from offering SSID
Hello,I've got two WCS and two WLCs and about 75 lightweight APs. I've got 3 SSIDs. One guest, and two production networks. I have an area of the building where I do not want the guest SSID to be available. How can I prevent one AP from accepting...
Resolved! Cisco 5508 Controller & AES Encryption
A wlan on my controller is configured for WPA2, AES encryption and a PSK. A vendor will supply me with a wireless device for this wlan. The vendor asks if we use AES 128 or AES 256. I had always believed we use AES256 but I can't verify this. How...
Hi ,I've a number 1242AG APs that i want to reconfigure. These APs were in use before but i've reset to factory defaults on NCS.When i console into the APs now, using independant power source, and try to paste in my config i get"ERROR!!! Command is d...
Hi All, Below is bridge configration . I would like to know with this below configuration data traffic will get compelete encrytion ?? any better encryption configuration ?? as I read wpa will not provide complete encryption. please helpnetwor...
Hello,I have Cisco Wireless Controller 2500 series (AIR-CT2504) and 10 LAPs implemented in my office building. I need to enforce security policy.I have few questions below regarding the Wireless controller 2500 Series- Please advice.1) Can i enforce...
Hello my name is IvanI have a wlc 5508 with license base to 50 aps, i use a deployment flex connect. I already registered all my access points, I use web authentication to authenticate users guest, and the service dhcp is in the central site.My issue...
