Wireless

Hi,I have some problem with blackberry torch 9800. They can't connect or connect about 1 time of 25 attemps. I don't know why and it's pretty hard to troubleshoot. Other phone with wifi doesn't have problem. I got a Iphone 4 and it's always connect t...

I have a customer that has a wireless clean air deployment in their retail environment.The next step is to add AP's to cover a RF noisy environment, Cold storage areas.  According to the site survey's these areas are showing up as dead zones.I am sug...

Hi All,I have problem setting up wireless repeater using Cisco 1242AG access points. Here is the setup and problem -The location has 2 1242AG APs  and a WLC (2206) which will be used by PDAs. One of the AP was converted to Lightweight AP and is wired...

I use the Cisco VPN client version 4.6.04.0043 to VPN from home into my company's network. Once connected, I use the Cisco IP Communicator desktop phone v 2.1. If I'm using a hard wired connection, everything works fine. However, if I'm working wi...

Dear all,I read a lot about VPN via an iPhone (Cisco Anyconnect), but is there anyone who can tell me if or how I can make a VPN connection via my iPhone to my WRVS4400N v2?I have to fill in some fields in my VPN settings on my iPhone wich I can't fi...

Hi experts,We are in middle of deploying WiSM2s on our network, from a design point of view i am confused on where to position the WiSM2s. We have 2 DCs and from best practice architecture view WLCs should not be placed on the Data Centre segment, bu...

We have just discovered a problem with 802.1x authentication and Atheros cards.We have seen this on both MAC OS X 10.6.0 systems and an XP SystemThis appears to be a DHCP problem in that clients don't get an IP address unless they reboot- which usual...

Good morning, I am currently installating 3502 Lwapps across my enterprise. I am currently utilizing 3502i(internal antennas) in the customer facing areas and 3502e(external antennas) in the warehouse areas.  The 5 Ghz antennas are 3.5 dBi and the 2....

I am working with 4 x 1522 mesh ap's. 2 roots and 2 mesh. Both roots are connected via fiber (single strand SFP). The mesh was up and running then all of a sudden root 1 dropped off and joined back as a mesh. All the Ethernet interfaces from root 1 j...

ACS 5.1 EAP-PEAP Machine AuthenticationAll, I have configured ACS 5.1 to check AD domain computer accounts then permit access, the next rule authenticates AD domain users and checks machine accounts with WAS MACHINE AUTHENTICATED "TRUE" permit.My dil...

Is it possible to configure two 1300 series bridges at one location, each handling a bridge link to another location to BOTH backup and load balance for each other should one of them fail?

HI In my site i am running WCS with 5.0 version on a Linux server .From past 5 days i am seing the WCS application is not responding properly .Once i restarts the server it is working for some time and again its getting unresponsive .Did anyone faced...