Wireless

We have over 150 AP's installed. 1. I am noticing the below type of PING times from various clients attached to various AP's at different locations. Very few locations r reporting <2ms. Reply from 172.26.5.111: bytes=32 time=106ms TTL=127Reply from 1...

Is anyone using EAP-SPEKE password authentication? I have just been reading about it and can't find out if cisco ap's will support it?SAM

Hi, I'm trying to configure a mobility group between 4 WLC's. 2 of 4 form a group and those two are the two on the same cards.The two cards are on separate subnets and each have are connected to a FW. I've opened up for UDP12222-12223 UDP16666-16667 ...

I have been asked to make some changes to a 1310 AP at a new site. When I try to browse to the device, I get the login screen, but when I put in the username and password it say :not authorized. I can telnet into it and the username and password work...

Is there a limit to the number of DHCP overides you can use per controller?

How many Cisco Aironet 1250 APs running 3x2 at 20mW under Cisco Enhanced PoE are supported on 3750E-48PD? Does it change with 3750E-48PD-F? How about X4648+E blade from 6500? Where can I find a power calculator for 3750E? I once had a customer buy 48...

Hi all, We have a wireless network, consists of 1 access point that connects to 3 workgroup bridges, for some reason when I stop a ping going to all the access points, I can no longer reach devices the othr end of the workgroup bridges.Is there a rea...

Currently I have a few WiSM blades and a WCS. I was thinking of upgrading to newer code and was looking to see what the latest stable code is.The current WLC version is 4.2.112 and the WCS version is 4.2.81. Thanx, Seth

Our company has one building with many Cisco 1200 series access points running two radios. The company has a manufacturing and assembly area where there is open space and also a lot of manufacturing CNC machines.Recently the Cisco 1200 access points ...

I have two buildings that are just out of line of site...I need an antenna that can go through a couple of trees....the trees are not on our land so we cannot cut them down. I am using 1300 series Wireless Bridges.Thank You

wlc4402 5.0.148.0 Windows clients have very poor access to network resources inside of our network. The wlan is on a tagged interface associated to a port that is a vlan trunked port on our 6509. If a wlan that is associated to our non-tagged manag...

Hi,I have all of my WAP's connected and managed by my WLSE but it showing that they all have the same name under Devices > Group Management as well as when I try to deploy new templates. If I dig into device explorer it shows the "Full Name" as the w...

Hi Folks, i had to use the WCS Planner to make a quantity structure for a new Building. This Building has some Inner Courtyards, where WLAN coverage is undesired. How can i exclude these Areas from the Map in the Planner Tool? Any Idea? What is teh D...

i have a cisco air-1230b-a-k9 access point accidentally it was lost it's ios.while i tried to load ios through xmodem it is showing me that no space left in device. though there is no file system in flash