Wireless

When I configure multiple ssids they seem to work fine until I add any sort of security.When a add a simple WEP key my data vlan works fine, I can get to all the interfaces and networks, but my voice vlan does not it does get an IP from the dhcp serv...

Hi there,I am a little challenged to configure WPA2 with PSK on a c871W. I searched through Ciscos documentation but only found topics about WPA. So could you please advice me how to activate WPA2 (w/AES) on a 871W box?Thank you....Andy

We are running the LWAPP (2006 wlc's and 1242 AP's) and using the ACS 4.0 for authentication. Our users areexperiencing an issue, where they are successfully authenticated the first time, however as the number of them is increasing, they're starting ...

I have a cisco access point ( model : AIR-LAP-1242AG-T-K9). I want to know how can I access it through GUI. The IOS version is 12.3(7)JX . Is this version OK. What is the difference between LWAPP & Autonomous mode. What may b d IP adress of the acces...

Or just discover them?I have;Appliance 2.13wlse Fri Jan 6 23:20:18 UTC 2006 WLSE 1130 Release 2.13FCS Wed Feb 22 02:00:55 UTC 2006 (build number 299)

Hi Everyone. In discussions with cisco and other users, we are confused on mounting and radio coverage practices. should we be mounting the radio vertically with the ethernet to the side or Horizontal to the floor (drop ceiling). According to others,...

Hello...I am having issues with clients who are connecting to LWAPP APs. They are not able to obtain an IP address via DHCP. If I give them a static address on the VLAN they are trying to connect to, they get on fine. The WLC is handing out the IP ad...

Hi,I just purchased Aironet 1242 access point and want to convert the APfrom lightweight mode back to autonomous mode. I followed theinstruction from Cisco site:Step 1 The static IP address of the PC on which your TFTP serversoftware runs should be...

Hi - This is my first time using the 526 controllers. Here is the scenario: Two buildings connected via 1310 wireless bridges (one for voice, one for data). One building will have 6 521 APs, the other will have 1. I can't find documentation any w...

Hi,I am looking for a solution to provision wireless access to employees( internet and LAN access) and for "guest" (just internet access) from one central wireless control platform. Can you guys please suggest me some ideas?

I want the automatic redirection to the login page work when a proxy is configured in the IE parameters.I used the command "config network web-auth-port 8080", but when I open IE, I'm not redirected to the login page (the DNS request works).When I do...

Hello all. I've got two questions related to wireless QOS in a UWN world:1) A QOS profile is associated with a WLAN. Is it possible to diferentiate traffic within a single WLAN? Can I assign the gold profile to one DSCP value, and the silver profil...

Dear Sirs. I have installed AP1242 access point in rather harsh environment indoors. The AP is in 3 meters below the ceiling of the warehouse, however, the ceiling is not completely sealed. I've installed the AP on the vertical surface, so the upper ...