Wireless

I've read that this level 4 severity warning message indicates a potential error condition.A packet sent to the client has not been successfully delivered many times.I did not find a recommended action. What can I do to solve this problem?Thanks

I have found the following switchport configuration guide for use when connecting an AP that will be used to support Voice. The AP that will connect to this switch will be supporting both B & G Radios. If I apply this configuration it will effectivly...

Any one else having any quirky "stop work" issues with AP350s that are upgraded to IOS? We have about 15 or so deployed in a convention center that just mysteriously stop forwarding traffic. People are free to associate with them (since it’s wide o...

Hi,If i am using IPSEC 3DES VPN through 1200 series Aironet to a BlueSocket Wireless Gateway in Main mode, is there any need to use a WEP key.My thinking is that the IKE negotiate is encrypted after i think 3 packet exchanges so i can't really see th...

I am designing a wifi network to cover wifi access by laptop. I need to cover 1000 square feet of outdoor concrete. I will have 4 1310 AP's, one at each side. Since there is no power or cable out on the flight line the AP's will be at the edge of ...

Hello all,I need to check if I can make one BR1300/AP1200 (mode root) passing 802.1Q traffic to an WGB (in my case an AP1100).I also want wireless client PCs to connect to the BR1300/AP1200.Can you help me with some issues or configs that could help ...

Hi,I need to install some anntenas in a warehouse. The problem is that the warehouse is too high ( 20 metres ). Which is the best anntena to install?thanks

We would like to use 802.11a as the backhaul of our wireless systems at certain locations. whe we were configuring the test units, the configuration is almost identical to that of the 802.11G radio. Meaning, that it gives basically to genrall rools, ...

Using an 1100 running c1100-k9w7-mx.122-13.JA4.Without WEP(128 bit) it works fine. I am using it for 7920 wireless phones and laptop access. As soon as WEP is enabled both the phone and laptop associate to the AP, but cannot route, cannot ping the AP...

I must be missing something. When I select "use this AP as WDS", the Wireless Domain Services Priority field will not take input, and of course, I can not then apply WDS. Using system software version 12.3(2)JA2.I believe I have followed the insr...

We recently purchased a Cisco Airnet 1100 series Wireless Access Point. Everything is working fine on the Access Point so far (everyone can connect ok). The only problem we are having is getting the Event Log to display the correct time. Right now...

I am trying to get our wireless network up. I am using PEAP with MS-CHAPv2, ACS 3.3, 1100 series access points, WDS, Dell internal centrino cards, and Active Directory for user login. We currently are not using Group Policys but running logon scrip...

Hi,I have a customer who has a notebook that does not support LEAP. It supports a protocol called Protected EAP (PEAP).It's Authentication Method uses "Secured Password - EAP-MSCHAPv2" and I don't know whether it is supported in Cisco Aironet.The thi...

hiI am having a problem in accessing the Cisco ap 1200 B series with HTTP WRITTEN IN C CODEWhen i am doing that i am getting the response from the ap as401 Unauthorizedwith WWW.Authenticate:Basic realm=" level 15 cccess"< HEAD> <TITLE> Authorization ...

how to write a config file so that it can be configured through HTTP program.plz helpmalli