Wireless

I have 2 cisco 1410 wireless bridges approx. 4Km away from each other. One side has a sector antenna and the other is using a dish. When I attempt to connect them with the sector as the root, it associates and loses connection after a few seconds and...

Is is possible to include the new 877 Routers as part of the SWAN architecture, in particular, the WLSE?Thanks

Hi,All user configured on WLSE are configured with privilege level 0.When I try to connect on WLSE via Telnet I just can do a ping, traceroute,debug or a show command.Via Http : Admin->User Admin->Manage UserI can just set CLI Access to none or Level...

Hi All,The wlan client is connected properly to the AP.The ping from AP to client or vice versa does not work.1)If I do ping from AP to client:I observe that the ARP request from AP to client gets ARP response back successfully.However the ping reque...

I have been trying to configure a access point and keep losing the connection while doing basic config.It always happens after the access point has been up for 5 minutes and I lose the IP address assingned to my laptop by the dhcp server.Have tried i...

Hi Sir,Did anyone experience connectivity issue between Cisco Aironet 1100 Series AP and Intermec 750 Mobile Computer handheld scanner?I've implemented several Aironet 1100 in a hypermarket store. The users are using Intermec 750 scanners. The issue ...

i'm trying to tftp a new copy of the latest IOS as the current image in flash is corrupt.i got the tftp commands from the config guide but i keep running out of disk space.i need to be able to delete the existing image in flash but i can't find the c...

I'm trying to determine the propagation pattern of a Cisco AIR-ANT1728. The room that I will be using the antenna within has a high ceiling. I need to be sure I don't end up with a dead spot directly under the antenna. Where can I find specific anten...

Trying to find a way to secure a point-to-point link between 2 1310 bridges. The site has no access to an ACS server, and it appears that for some reason (why?) you can't run the "radius-server local" command on a bridge. Would like to use AES & WPA ...

I'm trying to replace the functionality of a Symbol Technologies CB1000a with a small bridge that will run in an EAP environment. Short of building an embedded processor running XPe with an a/b/g card...any ideas of a small footprint stand-alone EAP ...

Hi,I’m looking for a sample or best practice configuration to configure 2 Aironet 1310 in bridge mode, so that:- one bridge works in root bridge mode and only accepts the non-root bridge an no clients- root bridge only accepts one none root bridge- o...

Is there any wireless management module for cisco works? Forinstance, I prefer to view all access point alone without any other device being visible. Please advise!With cisco works currently, I do have to execute the layer 2 view aption, under networ...

I have a number of 1130 AP that are using EAP-TLS to log users onto the wireless network. I would like to move to using WDS but I am having issues with the access points authenticating with windows IAS server. I am receiving this error AP Authenticat...

dear,Is there a way while using leap & mobile ip technology to make it happen when a users becomes associated to an ap (proxy mobile) he always obtains an ip adres from a predefined pool or just one personal ip-adress which we define on our tacacs+/r...

All your documentation points to updating my firmware but when I try to update via browser the file will not load. Am I using the right file? Your documentation says to use the tar and that did not work so I untared the file and there are numerous fi...