IP Telephony and Phones

Hi, We are running CUCM 8.6 and CUC 8.6 with Single line (VOIP & PSTN) with Geo location Policy in place. Currently we have requirement like around 200 users are moving from Location A to Location B. Location A users extensions need to forwarded (O...

In doing some troubleshooting for a customer I find that the NTP service was set incorrectly on the Presence servers. Is there a way to get into the system to correct the NTP parameters so that they will not be unsynchronized? they are running in a C...

I managed to initiate calls by the protocol handlers (e.g. tel:+491511232323423) so Jabber dials the number for me on windows... but for dialing into our seamless communication platform with the respective conference numbers (e.g. "777888999#") On va...

Hi  I am new on this so i configured my Cisco 3560 switches which are going to be layer 2 with a simple command "auto qos voip trust" on all the ports including the trunk ports. we are going to use NEC ip phones and hope that this should work. pleas...

Greetings, I have a question that maybe someone can answer for me. Currently we are using a Cisco 1941 in combination with a VoIP PBX. In our standard configs we are using the following 2 lines to regarding VoIP operation: - no ip nat service sip u...

Hi,I am trying to install ESXI 5.0 on UCS C240 M3 with RAID 5, but getting stuck on selecting disk to install, there are 4 hard drive are installed but showing local: (none).attached are the snap shot of the installation.can anyone suggest?

Hi, Did anyone have a problem to log into WebDialer page using valid username/password? I used standard URL: https://CUCM_IP:8443/webdialer/Webdialer I get the following: HTTP Status 500 - type: Exception report message: description: The server...

Hi We have a 3925 ISRG2 configured as MGCP with CUCM 9.2 One of the ISDN lines as e1 is already operational. Now we have tried to connect another E1 in different slot but same module. But this new E1 is from different Telco. CRC is off at that end of...

Dear teamI tried to integrate Cisco Unity Express 8.6 with my cucm 9.2, and reached till initialization wizard, even imported one user with administrator rights.But after that it prompted for a reboot of unity module and since then CUE has not come u...

Hello. I have a problem with 7940G phone. I cannot press digital buttons when the handset is not raised. I can press when a handset is raised. Setting button works.I did a factory reset.

Hi everyone, Does anyone know how I can see via CLI the last activity (outgoing call) of all registered phones in the cluster? I went over the data dictionary for 8.6.2 but I can't seem to find such a timestamp. Preferably it should be human readabl...

Hi, I have tried to insert phone using above BAT file. But CUCM 10.5 says MAC Address/Device Name Error Code Error Description ----------------------------------------------------------------------------------------- 38ED1855F9D6 DEVICE :: Error : 4...

Hi guys, Can anyone help my out with this.Recently a company has changed from SIP provider X to SIP provider YVoice traffic is  based on SIP without any cube. SIP provider Y has provided me the signaling IP with port 5060I have modified the dial-pee...