Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi,I have customer complain that fxo port open before the extension answer the call which cause the call to be charged by telecom company the gateway is registered with call manager using mgcpso is there any configuration like opx in h323
Hello all - I'm new to CUCM and I am installing my first phone firmware pack since we had our CUCM install done. Following instructions at http://www.cisco.com/web/software/282074288/113778/cmterm-7821_7841_7861-sip.10-1-1SR2-readme.html. When I try ...
Hi All,What are the major differences between CUCM v7, v8 and v9 ? Thanks
We have a CME 8.6 Router(3945) with CUE 8.6 (ISM-SRE-300-K9 Module ) . I have some Concern regarding the installation and configuration of CUE.Does Cisco Ships CUE 8.6 Application Pre-installed on ISM-SRE-300-K9 Module ?What is the initial Stat...
Hello All, I have a few Cisco 7821 handsets that will not allow DTMF tones to pass to things like on-line banking. i.e "press 1 for x, press 2 for y", when i press "1" i hear the tone but the other end does nothing.It works with most other phone typ...
Hi all,I'm busy configuring some VG202 but it seems that at every apply config or reset, that some parameters are coming from the CUCM and this is making my configuration fail (with fax). Here are the points that are automatically pushed voice-port 0...
I am trying to get a pause in a speed dial to work on an 8945 IP Phone. I have configured the speed dial to dial 1234567,,129. After connecting the main number, I hear a quick "beep-beep" where the DTMF tones should be transmitted. Is there some sett...
Hello Experts,I have an requirement to configure a SIP trunk to one of the cloud provider who has a Asterisk PBX. Requirement is to register the SIP trunk on router with the cloud pbx. Then the calling number assigned should be able to route to an ex...
Hi Team, I have a Cisco 2951 voice gateway router which has CUE card. I have configured voice mail express and it working properly. Now I wants redundancy in CUE so my company plan to purchase a second voice gateway router. I wants to confirm is C...
Asterisk + cisco 3905 problem! Sometimes callers can not hear each other. Who knows how to solve this problem? What configurations need to provide?
Hello guys.. A quick one.. I'm testing the Message Waiting Indicator (MWI) on my Cisco Unity Connection Server.When I configured the MWI extension I just created one (the ON one)... then I went to Unity and put the same extension number on the ON and...
Dear All I am looking for a Call manager server is supported 5000 sip phones , what is the server model and version ? thanks ....
Hi Experts, when i tried to collect CDR file from CUCM GUI interface, i got the attached error. Moreover, when i do some investigations, i found " ERROR Failed to Flush writer, No space left on device" In addition, when i tried to do manual puge, i f...
I am plan to test a sip connection..,but i don't have CUBE licenses,kindly advice me what are information i need to get from telco in order to create BOQ.
Running CUCM 8.5 and using an 8961 SIP phone. I have some BLF SD buttons configured and they have been working until about a month ago. I cannot use the buttons to transfer calls.Answer a callPress Transfer (hard button) Press BLF SD button. The answ...
