IP Telephony and Phones

I have some MCS server that I don't have physical access to. I looked at the HKEY_LOCAL_MACHINE\Software\Cisco Systems\Model\Hardware key and they are either a MCS7845H03 or MCS7845H07. How do those values relate to the 7845H1 7845H2 etc?Thanks,Pat

Hi all,i have a cisco h323 gw with 2 fxs phones  connected to it. If a phone calls the othe using its internal number the call goes as expected, the terminating phone rings and the originating phone has its rinback tone. If I call a phone using a glo...

Good time of the day!Is it possible to change the default search field in Corporate Directory on CUCM 8.6? When you open Corporate Directory, the cursor is in the 'First Name' field and you have to press down key to move to the 'Last Name' field, whi...

I have a new telephony system that was implemented yesterday with Cisco Call Managers / Unity / Contact Center, etc.We also have xMedius Faxing Solution as well.  In a nutshell, our overall calls appear to be working fine.  However, our xMedius faxes...

Looking at INE topology for the ccie voice lab setup, I see that they used 3725 as a PSTN and Frame-Relay switch. I also see on their site the followingmodules they used in 3725 router(Qty 2) VWIC-2MFT-T1(Qty 1) VWIC-2MFT-E1(Qty 1) NM-HDV(Qty 2) PVDM...

Good time of the day!I've got another question about Cisco 9951 IP phones. If Cisco Unified Video Camera is connected and enabled, and video capabilities are enabled, by default all calls become video calls if both endpoints support it. This is not c...

Good time of the day!We have CUCM 8.6 and Cisco 9951 IP phones. I used feature control policy to enable some additional softkeys (e.g. 'PickUp'). Is there a way to reorder softkeys on these phones?

I have a few IDD service providers that allow users to make IDD calls by dialing the IDD code follow by the IDD number.All the various IDD service provider is already configured in my CUCM as route pattern.eg. 90XX, 90XX, 90XX, 90XX, 915XX.Users can ...

Hi We currenlty have 2 xCUCM run in our internal network, I like to allow user from public wifi network to register, make and recieved call.  I have think about put new callmanager in Public IP address making cluster with existing Callmanager, then t...

I just setup a call manager in Egypt. The PRI isdn switch type is primary-4ess, therefore it recognizes 011 as international. That's not how they dial INT in Egypt, in fact it's a mobile prefix. I know I need to setup a translation rule so it's not r...

Hey everyone,We have some field offices internationally who use analog lines connected via FXO ports on their CME. They have limited analog lines and too many users. My personal opinion is that they need additional analog lines or an E1 however they ...

Hi,our costumer has two employees that sometimes create “call-forward all” loops.Is there a possibility to prevent them from this?Is there a practicable workaround for that?Thanks for Information.