IP Telephony and Phones

Showing results for 
Search instead for 
Did you mean: 

Forum Posts

I'm interested in formatting the caller ID information that comes in from our PRI.  I've received requests to make the output more readable for the users.  When a call comes in, we see "1234567890".  I would like it to show the same number, but show ...

We have timed partitions setup at a school that only allow calls to ring classroom phones before and after classes. It is working. If for example you would call DN 2010 during class hours it would hit a CTI Route Point with the same DN (2010) that is...

johnnywan by Level 1
  • 1 replies
  • 0 Helpful votes

Dear all,I’ve Cisco Fax server with an SR140 and I would to configure 2 SIP trunk, 1 for each CallManager. I would liketo do that for redundancy. I’ve the possibility to add only 1 ip address on the SR140 config panel. Somebody can help me ?Thanks

fdemierre by Level 1
  • 2 replies
  • 0 Helpful votes

I have a call handler in unity-5 for Auto attendant. the call handler has the DN of a physical phone. now for all the calls that are either called directly to that phone device or cfwded from another phone to that extension, i would want the Auto att...

Hi! I have a strange problem with my UCM 8 and 2801 with E1Router IOS: c2801-advipservicesk9-mz.124-24.T.binI configure MGCP on my router:!controller E1 0/2/0 pri-group timeslots 1-16 service mgcp!interface Serial0/2/0:15 isdn bind-l3 ccm-manager!ccm...

paa by Level 1
  • 3 replies
  • 0 Helpful votes