Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
HiI have a problem with voice-port FXO, when an incoming call is active the caller no listen to the person that response the call,this is the configuration of port.voice-port 0/0/0 supervisory disconnect dualtone mid-call cptone MX timeouts call-dis...
Guys,when the user enters his/her FAC the actual code displays on the screen. is there anyway to have it hidden like the 7900 phones?thanks
Hi All,Is it possible to use the Cisco Phone designer with User Device profiles?So that when a user loggs into a phone through EM they can apply their personal touches to the phone. photo/ring tone.Example Scenario,Everyone inthe org has a UDP and no...
CUCM Sync with AD at presentCurrently numbers from corporate directory are coming through as 8 digits.Thats the way customer wants to leave it.Where should we perform a transformation back to 4 digit extension. So Transparently the 10 digit director...
i have a vic-2did, and my background information like the topic :http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a008010ff92.shtmland i have 3 did lines.and i had config voice port in immediate start:I had get "823T", need conv...
Hi,please , can you verify with me this switch configuration. i want to SpAN traffic from Voice Vlan , to record the calls on the SpAN server.thanks in advance.hicham
Can an agent send a team message?
I am attempting to upgrade my customer from UC 7.1 to 8.x. They are currently running on an MCS7845H2-K9-CMB2. I understand from the documentation that this server has a 72GB HDD and that for 8.x, I need a min of a 146GB HDD. I am having trouble loca...
I'm new to QoS, but I've been doing some reading and packet captures to learn. From what I can tell (from a sniffer) my phones mark SIP signalling as Type of Service 0x68 and the RTP voice as 0xb8. But when reading other documents about best practic...
Can these tokens be re-used? I want to test in the lab first before going on site tosetup with the customer but do not want to "dedicate" the tokens to my lab since they belong to the customer?
Ok, I am very new to CME, we just converted over last night. Over all things went well, but I have a VERY strange issue. I have a user that while she is on a call, hears ringing on the line. Not actually her phone ringing, but the ring you would expe...
UCM 7.1(5) to MGCP gateway.Calls to International numbers using @ pattern fail. The provider is needs plan/type unknown, UCM is sending ISDN/International.Any assistance is greatly appreciated.Brian
We have a setup where we have FAX machines connected to VG224. All FAX machines are working fine expect one. From that port if i connect Analogue phone then i am able to make outgoing call but for incoming result is same.Kindly help me out in resolvi...
Hi all,I have a situation where ASA behind a NAT device (load balancer). IP address public is attached to Load balancer. Is it possible to use Phone Proxy feature in ASA?Thank you.
Hello All,Is there a way to configure the new ISR G2 routers as an MGCP gateway under CallManager 4.x (specifically 4.2(3))? There are no options for the 2900 or 3900 models available for selection. Many thanks in advance for any assistance provide...
