IP Telephony and Phones

I have a WAN-based cluster.site A has Publisher as TFTP server, site A also has a backup TFTP server.SiteB has a subscriber without enabled TFTP service.during normal situation, phones at siteB will registered with SiteB subscriber server while using...

Greeings,I have a customer with several CME deployments and on the 7931 phones the Redial softkey gives me a "not active here" message. It works fine when I am off hook.Phone firmware is 8-3-2-27

I have a customer that I moved over his PRI from an old VG200 that was H323 in/out. The PRI is now connected to a 2811 with MGCP. Everything works fine, but outbound calls I can not get the main number to override some other number that is showin...

HiWe have an integration between CCM6 and Siemens. So, we use one route 50 to use a special lines on Siemens. This works fine.My doubt.On ccm 4.2, we created same speed dials with 50, so when I clicked the speed dial I listen the dial tone and I call...

My boss to aks for to limit calls to 3 minutes, is possible to do this?, I have call manager version 4.1

I am having the following problem with some incoming calls on a Q931 circuit in Germany.If from the UK I dial my customers number which ends 664080xx the called party number presented to the sites 2811 is the full 8 digits meaning the call can be rou...

Hi NetPro - I'm curious, suppose you set up UCM (5.X or above)to connect to MS Exchange UM via a SIP Trunk. When an IP Phone connects to Exchange UM, does the RTP audio stream go directly to the UM server, or does it pass through the CallManager?I'm ...

Hi,I am running cm5.1.3 is there anyway by which i can get detailed report of all the configs done in the callmanager, may be in pdf format which can be good for audit purpose of internal configurations.Thanks inn advance.

I got an issue with the above mention phone, details follow:A. Using Phone Firmware 'SCCP41.8-4-3S' - Local & Mobile outgoing call is not working.B. Using Phone Firmware 'SCCP41.8-4-1S' - Local & Mobile outgoing call work well.C. The reason being wh...

Hello all - having a strange problem here. We have had about 7 Cisco 7941 phones in the last week that have had problems getting dialtone when lifting the handset. They get a dialtone 100% of the time when hitting the speaker button. I have had CI...

We have bought a MCS-7825-H3-IPC1 to use as a new subscriber for Call Manager 4.2Does anyone know the part number for the platform discs to load the windows 2000 OS? The original discs do not work.Thanks

Hey Guys,I have a client here with a Call Manager 5.1 install with a full active partition. They cannot perform backups resulting in errors that the disk is full (which seems odd since it's only reading from the disk). Backup location has plenty of s...

Hi, CUCMBE - Version 7.0.2IP Communicator Clients can access the coprorate Directory but none of the 7940 or 7941s can get to it. They get "error, Contact Administator".Is this a phone template setting? Any ideas?Thanks,Heath

Hi, I have uploaded the cop.sgn file (Latest version) for the CUCM 7 via SFTP, I can see this file in dial plan installer, but when I click on install button, no work, just show page refresh, when click on uninstall button, I get a message that cop...